Siemens SINUMERIK 840Di sl Operating Manual page 393

8
01/2008
Alarm
log
Service
displays
PLC- status
Acknowl.
HMI alarm
Acknowl
SQ alarm
Safety Integrated
SI HW
bestätigen
SI Alarme
ausfiltern
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
The alarm log of alarms and messages that have occurred is
displayed. The log also includes alarms that have already been reset.
Default setting for the alarm buffer: 150 alarms/messages
You can view updated information about axes and drives installed in
your system under the "Service displays" softkey.
Information on the current status of the PLC memory locations.
Vertical softkeys
HMI alarms (alarm number 120...) that have occurred can be
acknowledged.
SQ alarms (PLC alarms) that have occurred can be acknowledged.
If the "Safety Integrated" option is active, in addition, the two following
softkeys are available in the "Alarms" main screen:
This softkey is only displayed if new hardware is found. Message
27035 is then output with the request to acknowledge the new
hardware components and to perform a function test (this depends on
the access level: As a minimum, key-operated switch position 3 is
required).
After this softkey has been pressed, the display of SI alarms is filtered-
out and suppressed in the "Alarms" window. The SI alarms are still
displayed in the header.
Diagnostics operating area
8.1 Diagnostics main screen
8
8-393