Siemens SINUMERIK 840Di sl Operating Manual page 266

6
"Program" operating area
6.4 Structured step sequence display (option)
Mark
block
Copy
block
Find/
Go to...
6-266
With collapsed display, the entire step is highlighted will all substeps
and can be copied or deleted as required.
With expanded display, the selected steps are highlighted.
Note
If you have switched between "Expanded" and "Collapsed" view while
sequences were highlighted, the highlighting is removed for the
sequences.
All selected steps are copied to the clipboard and can be inserted
anywhere in the active channel or in another channel program (step or
ASCII view). The clipboard is valid for each operating area at a time.
An editor which is, e.g., activated by the simulation or as a correction
editor cannot access the clipboard, which contains data created in the
Program operating area.
Find If the search term is located in the step identifier, the cursor is
positioned on the step. If the search term is not found within a step, a
message is displayed "Search text not found". This is because only
the displayed step identifiers are included in the search. The search
works in the same way in the collapsed step sequence display and
individual hits are only possible within the step identifier at zero level.
Go to: If the block number is located within a step, the cursor is
positioned on the primary level or secondary level of the step.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
6
01/2008
© Siemens AG 2008 All rights reserved.