Siemens SINUMERIK 840Di sl Operating Manual page 78

2
Operator Components/Operating Sequences
2.7 Job list
Selection
Unload
2-78
"Select" job list
If you select a job list or workpiece with job list, all instructions of the
job list are executed.
LOAD instructions are executed if the files are still stored on the HMI.
COPY instructions are executed only if the files are not stored on the
NC or if the file copy on the NC has a different time stamp to the HMI
copy. If the time stamps are different, the system asks whether the file
should be overwritten.
SELECT instructions are executed.
"Unload" job list
"Unload" means that the instructions of the job list are "undone", the
instructions in the job list are executed in reverse order, e.g.:
Data which have been loaded to a destination NC with a LOAD
instruction are unloaded from [destination] to [source] into the source
directory on the HMI.
Data which has been loaded to a destination NC with a COPY
instruction is deleted in the [destination] if the time stamps are
identical. If the file on the NC was changed, the user is prompted
whether the version from the NC is to be saved to the HMI.
With "Unload" only files are transferred from the passive file system of
the NC. If, for example, modifications have been made to the active
data in parameters, these must be saved beforehand.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
2
01/2008
© S iemens AG 2008 All rights reserved.