Show Commands - Alcatel-Lucent 7450 Quality Of Service Manual

Ethernet service switch; service router; extensible routing system

Hide thumbs Also See for 7450:

Table of Contents

Service SAP QoS Policy Command Reference

mode {native | pool-per-queue} — The mode species whether the WRED per queue is using the

slope-usage {default | exceed-low} — This parameter specifies congestion control to be used.

Show Commands

sap-ingress [policy-id] [association | match-criteria | hsmda | detail]

This command displays SAP ingress QoS policy information.

Special Cases

Show SAP Ingress Output — The following table describes SAP ingress show command

native FP3 WRED capabilities or the FP2 and later hardware pool per queue.

native - use the hardware per queue WRED capabilities of the FP3

and requires slope-usage exceed-low.

pool-per-queue - each queue uses its own pool and the WRED

capabilities of the pool to provide WRED per queue. This is

supported on both FP2 and later hardware and requires slope-

usage default.

default - maps the in, out, and exceed profile traffic to the high,

low, and exceed WRED slopes respectively; this is only supported

for pool-per-queue mode.

exceed-low - maps the out and exceed profile traffic to the low

and exceed WRED slopes with the in profile traffic using the

MBS drop tail. This is only supported for native mode.

Note: For consistency across 7950 XRS platforms, C-XMAs/XMAs are modeled in SR OS

(CLI and SNMP) as MDAs.

The command outputs in the following section are examples only; actual displays may differ

depending on supported functionality and user configuration.

The ID that uniquely identifies the policy.

Implies that this policy can only be applied to a single SAP.

Quality of Service Guide