Alcatel-Lucent 7450 Quality Of Service Manual page 633

Context config>qos
Description
This command copies existing QoS policy entries for a QoS policy-id to another QoS policy-id.
The copy command is a configuration level maintenance tool used to create new policies using existing
policies. It also allows bulk modifications to an existing policy with the use of the overwrite keyword.
Parameters
slope-policy — Indicates that the source policy ID and the destination policy ID are slope policy
overwrite — Specifies to replace the existing destination policy. Everything in the existing
ALA-7>config>qos# copy slope-policy default sp1
MINOR: CLI Destination "sp1" exists - use {overwrite}.
ALA-7>config>qos#overwrite
Slope Policy QoS Commands
slope-policy
Syntax [no] slope-policy name
Context config>qos
Description This command enables the context to configure a QoS slope policy.
Default
slope-policy "default"
Parameters name — The name of the slope policy.
time-average-factor
Syntax time-average-factor value
no time-average-factor
Context config>qos>slope-policy
Quality of Service Guide
IDs. Specify the source policy ID that the copy command will attempt to copy from and
specify the destination policy ID to which the command will copy a duplicate of the policy.
destination policy will be overwritten with the contents of the source policy. If overwrite is
not specified, an error will occur if the destination policy ID exists.
Values Valid names consist of any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string
contains special characters (#, $, spaces, etc.), the entire string
must be enclosed within double quotes.
Slope QoS Policies
633