Alcatel-Lucent 7450 Quality Of Service Manual page 438

QoS Queue Group Template Command Reference
egress
Syntax egress
Context cfg>qos>qgrps
Description This command enables the context to configure QoS egress queue groups. Egress queue group
templates can be applied to egress Ethernet ports to create an egress queue group.
Default
none
queue-group
Syntax queue-group queue-group-name [create]
no queue-group queue-group-name
Context cfg>qos>qgrps>egr
cfg>qos>qgrps>ingr
Description This command creates a queue group template. The system does not maintain default queue groups or
queue group templates. Each queue group template used in the system must be explicitly created.
The queue-group-name parameter is required when executing the queue-group command and
identifies the name of the template to be either created or edited. Each ingress queue group template
must be uniquely named within the system. Multiple ingress queue group templates may not share the
same name. An ingress and egress queue group template may share the same name.
The no form of the command removes the specified queue group template from the system. If the
queue group template is currently in use by an ingress port, the command will fail. If group-name does
not exist, the command has no effect and does not return an error.
Default none
Parameters
queue-group-name — Specifies the name of the queue group template up to 32 characters in
create — Keyword used to create the queue group instance. The create keyword requirement can
policer
Syntax policer policer-id [create]
no policer policer-id
Context config>qos>queue-group-templates>ingress>queue-group
config>qos>queue-group-templates>egress>queue-group
Description
This command is used in ingress and egress queue-group templates to create, modify, or delete a
policer.
438
length.
be enabled/disabled in the environment>create context.
Quality of Service Guide