Alcatel-Lucent 7450 Quality Of Service Manual page 345

This command takes precedence over the de-mark command if both are specified in the same policy
and over the default action.
If no de-mark commands are used, the DE bit is preserved if an ingress outer or single tag exists, or
set to zero otherwise.
This command is supported on FP2 and higher based hardware, and is otherwise ignored.
Values: 0 or 1
dot1p-inner
Syntax [no] dot1p-inner {dot1p-value | in-profile dot1p-value out-profile dot1p-value}
Context config>qos>sap-egress>fc
Description This command explicitly defines the egress inner VLAN tag IEEE 802.1p (dot1p) bits marking for fc-
name. When the marking is set, all packets of fc-name that have either an inner IEEE 802.1q or IEEE
802.1p encapsulation on a qinq SAP will use the explicitly defined dot1p-value. If the egress packets
for fc-name are not IEEE 802.1q or IEEE 802.1p qinq encapsulated, this command has no effect.
The optional in-profile | dot1p-value out-profile dot1p-value parameters on the dot1p-inner
command adds the capability to mark the in and out of profile status on an egress qinq SAP. The
command with the additional parameters may be used on the SAP when the internal in and out of
profile status needs to be communicated to an access network/customer device that does not support
the DE bit. Once the in-profile keyword is added, then the rest of the structure must be specified.
When these commands are used, the DE Bit or the equivalent field is left unchanged by the egress
processing if an inner tag exists. If a new inner tag is added, the related DE bit is set to 0. The in or out
profile status may be indicated via the setting of the DE bit setting if the de-mark(-inner) command
is used.
The two versions of the command (with and without parameters) are mutually exclusive.
This command takes precedence over the dot1p command if both are specified in the same policy and
over the default action where the marking is taken from packet received at ingress.
The configuration of qinq-mark-top-only under the SAP egress takes precedence over the use of the
dot1p-inner in the policy, that is, the inner VLAN tag is not remarked when qinq-mark-top-only is
configured (the marking used for the inner VLAN tag is based on the current default which is governed
by the marking of the packet received at the ingress to the system).
The no form of the command sets the inner IEEE 802.1p or IEEE 802.1q priority bits to 0.
This command is supported on FP2 and higher based hardware, and is otherwise ignored.
Remarking the inner dot1p is not supported based on the profile result of egress policing.
Default 0
Quality of Service Guide
Service Egress and Ingress QoS Policies
345