Alcatel-Lucent 7450 Quality Of Service Manual page 327

Description This command is used to configure the policer's CIR leaky bucket's exceed threshold. The CIR
bucket's exceed threshold represents the committed burst tolerance allowed by the policer. If the
policer's forwarding rate is equal to or less than the policer's defined CIR, the CIR bucket depth hovers
around the 0 depth with spikes up to the maximum packet size in the offered load. If the forwarding
rate increases beyond the profiling rate, the amount of data allowed to be in-profile above the rate is
capped by the threshold.
The policer's cbs size defined in the QoS policy may be overridden on an sla-profile or SAP where
the policy is applied.
The no form of this command returns the policer to its default CBS size.
Default
64 kilobytes when CIR = max, otherwise, 10ms volume of traffic for a configured non zero/non max
CIR.
Parameters size [bytes | kilobytes] — The size parameter is required when specifying cbs and is expressed as
bytes — When byte is defined, the value given for size is interpreted as the queue's MBS value
kilobytes — When kilobytes is defined, the value is interpreted as the queue's MBS value given
enable-dscp-prec-remarking
Syntax [no] enable-dscp-prec-remarking
Context config>qos>sap-egress>policer
Description
This command enables DSCP/precedence remarking based on the profile state of a packet being
forwarded by a SAP or subscriber egress policer. The DSCP/precedence can be remarked to a value
independent of the packet's profile, or separately based on if the packet have an exceed, in-profile or
out-of-profile state.
Default no enable-dscp-prec-remarking
enable-exceed-pir
Syntax
Context config>qos>sap-egress>policer
cfg>qos>qgrps>egr>qgrp
Quality of Service Guide
an integer representing the required size in either bytes or kilobytes. The default is kilobytes.
The optional byte and kilobyte keywords are mutually exclusive and are used to explicitly
define whether size represents bytes or kilobytes.
given in bytes.
in kilobytes.
Values
0 – 16777216 or default
Default kilobytes
[no] enable-exceed-pir
Service Egress and Ingress QoS Policies
327