Alcatel-Lucent 7450 Quality Of Service Manual page 116

Ethernet service switch; service router; extensible routing system

Hide thumbs Also See for 7450:

Table of Contents

Network QoS Policy Command Reference

config>qos>network>ingress

This command creates a mapping between the DiffServ Code Point (DSCP) of the network ingress

traffic and the forwarding class.

Ingress traffic that matches the specified DSCP will be assigned to the corresponding forwarding class.

Multiple commands can be entered to define the association of some or all sixty-four DiffServ code

points to the forwarding class. For undefined code points, packets are assigned to the forwarding class

specified under the default-action command.

The no form of this command removes the DiffServ code point to forwarding class association. The

default-action then applies to that code point value.

dscp-name — The name of the DiffServ code point to be associated with the forwarding class.

DiffServ code point can only be specified by its name and only an existing DiffServ code

point can be specified. The software provides names for the well known code points.

The system-defined names available are as follows. The system-defined names must be

referenced as all lower case exactly as shown in the first column in

Additional names to code point value associations can be added using the 'dscp-name dscp-

name dscp-value' command.

The actual mapping is being done on the dscp-value, not the dscp-name that references the

dscp-value. If a second dscp-name that references the same dscp-value is mapped within the

policy, an error will occur. The second name will not be accepted until the first name is

Table 21: Default DSCP Names to DSCP Value Mapping Table

Quality of Service Guide