Alcatel-Lucent 7450 Quality Of Service Manual page 350

Service SAP QoS Policy Command Reference
adv-config-policy
Syntax [no] adv-config-policy policy-name
Context config>qos>sap-ingress>queue
config>qos>sap-egress>queue
Description This command specifies the advanced QoS policy. The advanced QoS policy contains only queue and
policer child control parameters within a child-control node.
Once a policy is created, it may be applied to a queue or policer defined within a sap-egress or sap-
ingress QoS policy. It may also be applied to a queue or policer defined within an ingress or egress
queue-group template. When a policy is currently associated with a QoS policy or template, the policy
may be modified but not deleted (even in the event that the QoS policy or template is not in use).
The no form of this command removes the specified advanced policy.
Default
None
Parameters policy-name — The name of the advanced QoS policy.
adaptation-rule
Syntax adaptation-rule [pir adaptation-rule]
no adaptation-rule
Context config>qos>sap-egress>hsmda-queues>queue
Description This command defines the method used by the system to derive the operational CIR and PIR settings
when the queue is provisioned in hardware. For the CIR and PIR parameters individually, the system
attempts to find the best operational rate depending on the defined constraint. This command applies
only to the 7450 ESS and 7750 SR.
The no form of the command removes any explicitly defined constraints used to derive the operational
CIR and PIR created by the application of the policy. When a specific adaptation-rule is removed,
the default constraints for rate and cir apply.
Default adaptation-rule pir closest cir closest
350
Values Valid names consist of any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string
contains special characters (#, $, spaces, etc.), the entire string
must be enclosed within double quotes.
Quality of Service Guide