Alcatel-Lucent 7450 Quality Of Service Manual page 739

pool-name — The specified pool-name identifies a named pool where the policy will be applied.
pool
Syntax pool pool-name [create]
no pool pool-name
Context config>qos>sap-ingress>queue
config>qos>sap-egress>queue
Description This command is utilized once the queue is created within the policy. The pool command may be used
to either remove the queue from the pool, or specify a new pool name association for the queue. The
pool command does not appear in save or show command output. Instead, the current pool name for
the queue will appear (or not appear) on the queue command output using the pool keyword.
The no form of the command removes a named pool association for the queue. When the pool name
is removed, the queue will be placed on the appropriate default pool.
Default None
Quality of Service Guide
priority-mode: The queue is capable of handling traffic
differently with two distinct priorities. These priorities are
assigned by the stages preceding the queueing framework in the
system. In priority mode, the queue does not have the
functionality to support the profiled traffic and in such cases the
queue will have a degraded performance. However, the converse
is not valid and a queue in profile mode should be capable of
supporting the different priorities of traffic.
Each queue created within the system is tied to a physical port. When the policy is applied
and the queue is created, the system will scan the named pools associated with the port to find
the specified pool name. If the pool is not found on the port, the system will then look at
named pools defined at the ports XMA or MDA level. If the pool name is not found on either
the port, XMA, or MDA, the queue will be marked as 'pool-orphaned' and will be mapped to
the appropriate default pool. If the pool comes into existence, the queue will be moved from
the default pool to the new named pool and the 'pool-orphaned' state will be cleared. The
specified name must be an ASCII name string up to 16 characters long.
Values Any valid ASCII name string
Default None
The queue's pool association may only be removed by either re-executing the queue
command without the pool keyword or by executing the no pool command within the queue's
CLI context. When the pool name is removed, the queue will be placed on the appropriate
default pool.
Named Pools
741