Alcatel-Lucent 7450 Quality Of Service Manual page 314

Service SAP QoS Policy Command Reference
Description This command configures a VXLAN or VXLAN GPE VNI to be used as a SAP QoS policy match
criterion. A range of VNIs to be matched can be specified by including the keyword range with a start
and end VNI. This command requires the type to be set to vxlan-vni in the related ip-criteria or ipv6-
criteria context.
See
Default n/a
Parameters
eq vxlan-vni-id — Specifies the VXLAN or VXLAN GPE VNI to be matched in the SAP ingress
range start end — Identifies a range of VNIs to be used as matching criteria. The start value must
Service Ingress MAC QoS Policy Match Commands
dot1p
Syntax dot1p dot1p-value [dot1p-mask]
no dot1p
Context config>qos>sap-ingress>mac-criteria>entry
Description The IEEE 802.1p value to be used as the match criterion.
Use the no form of this command to remove the dot1p value as the match criterion.
Default
None
Parameters dot1p-value — Enter the IEEE 802.1p value in decimal.
dot1pmask — This 3-bit mask can be configured using the following formats:
314
Virtual Network Identifier (VNI) Classification
QoS classification. The VNI can be specified in any of the available formats but is always
shown in decimal.
Values 1 to 16777215 (Decimal)
0x1..0xFFFFFF (Hexadecimal)
[0b1..0b111111111111111111111111] (Binary)
be lower than the end value. The VNI can be specified in any of the available formats but is
always shown in decimal.
Values 1 to 16777215 (Decimal)
0x1..0xFFFFFF (Hexadecimal)
[0b1..0b111111111111111111111111] (Binary)
Values 0 to 7
Format Style
Decimal
for the list of restrictions for this command.
Format Syntax
D
Example
4
Quality of Service Guide