Alcatel-Lucent 7450 Quality Of Service Manual page 342

Ethernet service switch; service router; extensible routing system

Hide thumbs Also See for 7450:

Table of Contents

Service SAP QoS Policy Command Reference

policy-id — The policy-id uniquely identifies the policy on the router.

policy-name — The policy-name uniquely identifies the policy.

[no] de-mark [force de-value]

config>qos>sap-egress>fc

This command is used to explicitly define the marking of the DE bit for fc fc-name according to the

in-profile, out-of-profile, or exceed-profile status of the packet (fc-name may be used to identify the

dot1p-value).

If no de-value is present, the default values are used for the marking of the DE bit: for example, 0 for

in-profile packets, 1 for out-of-profile or exceed-profile packets– see IEEE 802.1ad-2005 standard.

In the PBB case, for a Backbone SAP (B-SAP) and for packets originated from a local I-VPLS/PBB-

Epipe, the command dictates the marking of the DE bit for both the BVID and ITAG.

If this command is not used, the DE bit should be preserved if an ingress TAG exist or set to zero

If the de-value is specifically mentioned in the command line it means this value is to be used for all

the packets of this forwarding class regardless of their in/out of profile status.

The commands de-mark-inner and de-mark-outer take precedence over the de-mark command if

both are specified in the same policy.

Values: 0 or 1

[no] dot1p {dot1p-value | in-profile dot1p-value out-profile dot1p-value [exceed-profile

dot1p-value]}

Valid names consist of any string up to 64 characters long.

Policies must first be created with a policy-id, after which a

policy-name can be assigned and used as an alias to reference the

policy during configuration changes. Policy names may not begin

with a number (0-9) or the underscore "_" character (e.g.

_myPolicy). "default" can not be used as policy names. Saved

configurations and display output from the "info" and most

"show" commands will show the policy-id (not the policy-name)

where the policies are referenced.

Quality of Service Guide