Alcatel-Lucent 7450 Quality Of Service Manual page 324

Service SAP QoS Policy Command Reference
Parameters policer-id — When the forwarding class policer command is executed, a valid policer-id must be
port-redirect-group-queue — Used to override the forwarding class default egress queue
queue queue-id — This parameter overrides the forwarding class default egress queue
group queue-group-name — The group queue-group-name is optional and is used to override
queue group-queue-id — The queue group-queue-id is optional when the group queue-group-
instance instance-id — This parameter is used to specify the specific instance of a queue group
324
specified. The parameter policer-id references a policer-id that has already been created
within the sap-egress QoS policy.
Values 1 to 63
Default
none
destination to an egress port queue group. The specific egress queue group instance to use is
specified at the time that the QoS policy is applied to the SAP. Therefore, this parameter is
only valid if SAP based redirection is required.
destination to a specified queue-id. If port-redirect-group is not configured, then this will be
a local SAP queue of that queue-id. A queue of ID queue-id must exist within the egress QoS
policy. If port-redirect-group-queue is configured then the the queue queue-id in the egress
port queue group instance is used.
Values 1 to 8
Default Derived from forwarding class assignment in queue-group
definition.
the forwarding class's default egress queue destination. If the queue group-queue-id
parameter is not specified, the forwarding class map within the specified group's template is
used to derive which queue within the group will receive the forwarding class's packets. An
egress queue group template must exist for the specified queue-group-name or the policer
command will fail. The specified queue-group-name must also exist as an egress queue group
on the ports where SAPs and subscribers associated with the sap-egress policy is applied or
the policer command will fail.
Values
Any qualifying egress queue group name
Default policer-output-queues
name parameter is specified and is used to override the forwarding class mapping within the
group's egress queue group template. The specified group-queue-id must exist within the
group's egress queue group template or the policer command will fail.
Values 1 to 8
Default
Derived from forwarding class assignment in queue-group
definition
with template queue-group-name to which this queue should be redirected. This parameter is
only valid for queue groups on egress ports where policy based redirection is required.
Values 1 to 40960
Default 1
Quality of Service Guide