Alcatel-Lucent 7450 Quality Of Service Manual page 748

Named Pools QoS Policy Command Reference
Parameters pool-name — The specified pool-name identifies a named pool where the policy will be applied.
Show Commands
Named Pool Show Commands
named-pool-policy
Syntax named-pool-policy
named-pool-policy policy-name [detail]
named-pool-policy policy-name association
Context show>qos
Description
This command displays information on named pool policies.
Parameters policy-name — Each named pool policy must be uniquely named within the system. Names of up
detail — Displays detailed information on the given policy name.
association — Displays the associations connected to the given policy name.
Output
Sample Output
show qos named-pool-policy
===============================================================================
Named-Pool Policies
===============================================================================
Policy Name
-------------------------------------------------------------------------------
test
test57
750
Each queue created within the system is tied to a physical port. When the policy is applied
and the queue is created, the system will scan the named pools associated with the port to find
the specified pool name. If the pool is not found on the port, the system will then look at
named pools defined at the ports XMA or MDA level. If the pool name is not found on either
the port, XMA, or MDA, the queue will be marked as 'pool-orphaned' and will be mapped to
the appropriate default pool. If the pool comes into existence, the queue will be moved from
the default pool to the new named pool and the 'pool-orphaned' state will be cleared. The
specified name must be an ASCII name string up to 32 characters long.
to 32 ASCII characters are supported with the normal character restrictions. A named pool
policy must exist prior to applying the policy name to an XMA, MDA, or port.
Values Up to 32 character ASCII string
Description
(not-specified)
(not-specified)
Quality of Service Guide