Alcatel-Lucent 7450 Quality Of Service Manual page 741

Any changes made to an existing policy, using any of the sub-commands, will be applied immediately
to all egress SAPs where this policy is applied. For this reason, when many changes are required on a
policy, it is highly recommended that the policy be copied to a work area policy-id. That work-in-
progress policy can be modified until complete and then written over the original policy-id. Use the
config qos copy command to maintain policies in this manner.
The no form of the command deletes the sap-egress policy. A policy cannot be deleted until it is
removed from all service SAPs where it is applied. When a sap-egress policy is removed from a SAP,
the SAP will revert to the default sap-egress policy-id 1.
The system default sap-egress policy is a special case. The no command restores the factory defaults
to policy-id 1.
Parameters policy-id — The policy-id uniquely identifies the policy on the router.
Shared Queue QoS Commands
shared-queue
Syntax shared-queue policy-name
Context config>qos
Description This command enables the context to modify the QoS default shared-queue policy.
Parameters policy-name — The name of the default shared-queue policy.
queue
Syntax queue queue-id [queue-type] [profile-mode | priority-mode] [multipoint] pool pool-name
queue queue-id [queue-type] [multipoint] pool pool-name
no queue queue-id
Context config>qos>shared-queue
Description
This command creates the context to configure a shared queue QoS policy queue.
Quality of Service Guide
Default
none
Values 1 to 65535
Values default
Named Pools
743