Egress Sap Forwarding Class And Forwarding Profile Overrides - Alcatel-Lucent 7450 Quality Of Service Manual

Service Egress QoS Policy
The queue-delay command and the mbs command are mutually exclusive. In order to change
between the mbs and queue-delay parameters, the current parameter must be removed before
adding the new parameter, that is, changing from mbs to queue-delay requires a no mbs
before the queue-delay is configured and changing from queue-delay to mbs requires a no
queue-delay before the mbs is configured. If queue-delay is configured for an egress queue
group queue, it is not possible to override the MBS for that queue.
An example of configuring queue delay and the resulting MBS is shown below:
*B:PE# configure qos queue-group-templates egress queue-group "qg2"
*B:PE>cfg>qos>qgrps>egr>qgrp# info
----------------------------------------------
queue 1 best-effort create
----------------------------------------------
*B:PE>cfg>qos>qgrps>egr>qgrp# exit all
*B:PE# show pools access-egress 5/1/1 queue-group "qg2" instance 1
...
===============================================================================
Queue : accQGrp->qg2:1(5/1/1)->1
===============================================================================
FC Map
Tap
Admin PIR
Admin CIR
Admin MBS
Hi Prio Only
CBS
Slope
Egress SAP Forwarding Class and Forwarding Profile
196
configure
qos
queue-group-templates
egress
queue-group <queue-group-name> create
rate 50000
queue-delay 100
exit
: not-applicable
: not-applicable
: 50000
: 0
: 612 KB
: 72 KB
: 0 KB
: not-applicable
queue <queue-id>
queue-delay <ms>
Oper PIR : 50000
Oper CIR : 0
Oper MBS : not-applicable
Hi Low Prio Only : 132 KB
Depth : 0
Quality of Service Guide