Alcatel-Lucent 7450 Quality Of Service Manual page 287

Ethernet service switch; service router; extensible routing system
Hide thumbs Also See for 7450:
Table of Contents

Advertisement

A packet that is explicitly remarked at ingress will not be affected by any egress remarking decision.
Explicit ingress remarking has highest priority.
The no form of the command disables ingress remarking of out-of-profile packets classified to the
forwarding class or sub-class.
Default
none
Parameters
dscp dscp-name — This parameter is one of two mutually exclusive settings that are applicable
prec ip-prec-value — This parameter is one of two mutually exclusive settings that are applicable
Quality of Service Guide
SAP Ingress Packet State
Non-Routed, Policed In-Profile
Non-Routed, Policed Out-of-Profile
Non-Routed, Explicit In-Profile
Non-Routed, Explicit Out-of-Profile
IP Routed, Policed In-Profile
IP Routed, Policed Out-of-Profile
IP Routed, Explicit In-Profile
IP Routed, Explicit Out-of-Profile
to the out-remark command. The out-remark command can be configured to either remark the
DiffServ Code Point (DSCP) six bit value or the three Precedence bits. The dscp parameter
specifies that the matching packets DSCP bits should be overridden with the value
represented by dscp-name.
32 characters, maximum. The name specified by dscp-name is used to refer to the six bit value
represented by dscp-name. It must be one of the predefined DSCP names defined on the
system.
Values
be, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cs1, cp9, af11, cp11, af12,
cp13, af13, cp15, cs2, cp17, af21, cp19, af22, cp21, af23, cp23,
cs3, cp25, af31, cp27, af32, cp29, af33, cp31, cs4, cp33, af41, c
p35, af42, cp37, af43, cp39, cs5, cp41, cp42, cp43, cp44, cp45, e
f, cp47, nc1, cp49, cp50, cp51, cp52, cp53, cp54, cp55, nc2, cp57,
cp58, cp59, cp60, cp61, cp62, cp63
Default
None (an explicit valid DSCP name must be specified)
to the out-remark command. The out-remark command can be configured to either remark the
DiffServ Code Point (DSCP) six bit value or the three Precedence bits. The prec parameter
specifies that the matching packets Precedence bits should be overridden with the value
represented by prec-value.
Service Egress and Ingress QoS Policies
Table 28: Out-remark command effect
'out-remark' Command Effect
No Effect (non-routed packet)
No Effect (non-routed packet)
No Effect (non-routed packet)
No Effect (non-routed packet)
No Effect (in-profile packet)
out-remark value applied to IP header ToS field
No Effect (in-of-profile packet)
out-remark value applied to IP header ToS field
287

Advertisement

Table of Contents
loading

This manual is also suitable for:

79507750

Table of Contents