Alcatel-Lucent 7450 Quality Of Service Manual page 310

Service SAP QoS Policy Command Reference
To match on the IPv4 or IPv6 destination address, specify the address and its associated mask, e.g.,
10.1.0.0/16. The conventional notation of 10.1.0.0 255.255.0.0 can also be used for IPv4.
The no form of this command removes the destination IPv4 or IPv6 address match criterion.
Default No destination IP match criteria
Parameters ip-address — Specifies the destination IPv4 address specified in dotted decimal notation.
mask — Specify the length in bits of the subnet mask.
ipv4-address-mask — Specify the subnet mask in dotted decimal notation.
ip-prefix-list — creates a list of IPv4 prefixes for match criteria in QoS policies. An ip-prefix-list
prefix-list-name — A string of up to 32 characters of printable ASCII characters. If special
ipv6-address — The IPv6 prefix for the IP match criterion in hex digits (applies to the 7750 SR
prefix-length — The IPv6 prefix length for the ipv6-address expressed as a decimal integer
mask — Eight 16-bit hexadecimal pieces representing bit match criteria.
dst-port
Syntax dst-port {lt | gt | eq} dst-port-number
dst-port range start end
no dst-port
Context config>qos>sap-ingress
config>qos>sap-ingress>ip-criteria>entry>match
config>qos>sap-egress>ip-criteria>entry>match
config>qos>sap-ingress>ipv6-criteria>entry>match
config>qos>sap-egress>ipv6-criteria>entry>match
310
Values
ip-address: a.b.c.d
Values
1 to 32
Values
a.b.c.d (dotted quad equivalent of mask length)
must contain only IPv4 address prefixes.
characters are used, the string must be enclosed within double quotes.
and 7950 XRS).
Values
ipv6-address x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x::d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
(applies to the 7750 SR and 7950 XRS).
Values 1 to 128
Values x:x:x:x:x:x:x (eight 16-bit pieces)
Quality of Service Guide