Alcatel-Lucent 7450 Quality Of Service Manual page 339

dscp
Syntax dscp {dscp-name | in-profile dscp-name out-profile dscp-name [exceed-profile dscp-
name]}
no dscp
Context config>qos>sap-egress>fc
Description This command configures a DiffServ Code Point (DSCP) code point to be used for remarking packets
from the specified FC. If the optional exceed/in/out-profile is specified, the command will remark
different DSCP code points depending on whether the packet was classified to be exceed, in, or out-
of-profile ingress to the node.
This is supported on FP2- and higher-based line cards for the 7450 ESS.
Default not enabled
Parameters dscp-name — Specifies a dscp name that has been previously mapped to a value using the dscp-
exceed-profile dscp-name — This optional parameter specifies the dscp name to be used to
in-profile dscp-name — This parameter specifies the dscp name to be used to remark the traffic
out-profile dscp-name — This parameter specifies the dscp name to be used to remark the traffic
prec
Syntax prec {ip-prec-value | in-profile ip-prec-value out-profile ip-prec-value [exceed-profile ip-
prec-value]}
no prec ip-prec-value
Context config>qos>sap-egress>fc
Quality of Service Guide
d. dropped-in = 4
e. forward-in = 7
f. forward-out = 8
g. forward-exceed = 9
name command. The DiffServ code point can only be specified by its name.
Values be, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cs1, cp9, af11, cp11, af12,
cp13, af13, cp15, cs2, cp17, af21, cp19, af22, cp21, af23, cp23,
cs3, cp25, af31, cp27, af32, cp29, af33, cp31, cs4, cp33, af41, c
p35, af42, cp37, af43, cp39, cs5, cp41, cp42, cp43, cp44, cp45, ef,
cp47, nc1, cp49, cp50, cp51, cp52, cp53, cp54, cp55, nc2, cp57,
cp58, cp59, cp60, cp61, cp62, cp63
remark the traffic which is exceed-profile. If not specified, this defaults to the same value
configured for out-profile parameter.
which is in-profile.
which is out-profile.
Service Egress and Ingress QoS Policies
339