Alcatel-Lucent 7450 Quality Of Service Manual page 624

Overview
Ports
The following CLI syntax examples may be used to apply slope policies to port pools:
CLI Syntax:
MDA (FP1)
The following CLI syntax examples may be used to apply slope policies to MDA pools:
CLI Syntax:
For the MC Path Mgmt, the slope policy is configured within a multicast management
bandwidth policy which is then applied under the MDA ingress multicast-path-management.
CLI Syntax:
The following CLI syntax example configures the PPP multilink pool:
CLI Syntax:
FP (FP2 and higher based hardware)
The following CLI syntax examples may be used to apply slope policies to FP pools:
CLI Syntax:
Although these commands are applied under the MDA CLI tree, the policy is applied to the
FP. If different policies are applied to each MDA, the last policy applied take precedence.
For the MC Path Mgmt, the slope policy is configured within a multicast management
bandwidth policy which is then applied under the FP ingress multicast-path-management.
624
config>port>access>ingress>pool>slope-policy name
config>port>access>egress>pool>slope-policy name
config>port>network>egress>pool>slope-policy name
config>card>mda>access>ingress>pool>slope-policy name
config>card>mda>access>egress>pool>slope-policy name
config>card>mda>network>egress>pool>slope-policy name
config>mcast-mgmt>bw-plcy> mcast-pool percent-of-total
<percent-of-buffers> resv-cbs <percent-of-pool> slope-
policy <policy-name>
config>card>mda>ingress>mcast-mgmt# bandwidth-policy
<policy-name>
config>card>mda>access>egress>pool>slope-policy name
config>card>mda>access>ingress>pool>slope-policy name
config>card>mda>access>egress>pool>slope-policy name
config>card>mda>network>ingress>pool>slope-policy name
config>card>mda>network>egress>pool>slope-policy name
Quality of Service Guide