Updating The Lcdc For The Operation Panel - Ricoh B202 Service Manual

Hide thumbs Also See for B202:

Table of Contents

FIRMWARE UPDATE

5.6.3 UPDATING THE LCDC FOR THE OPERATION PANEL

Do the following procedure to update the LCDC (LCD Control Board).

1. Turn the copier main switch off.

2. Insert the SD card into SD Card Slot 3.

3. Switch the copier main switch on.

4. The initial screen opens in English after about 45 seconds.

5. Touch "Op Panel.xx".

NOTE: "xx" differs depending on the destination.

6. Touch "UpDate(#) or () to start the update.

Downloading starts after about 9 seconds.

The operation panel goes off and the main power on key flashes in red at 0.5 s

intervals when the data is downloading. The same key starts flashing in green

at 1 s intervals when the update is finished.

7. Switch the copier main power switch off and remove the SD card. Then switch

the copier on.

B202/B178/B180

Table of Contents