Model Type - GRAUPNER mz-24 Pro Programming Manual

Model Type

Changing the Model Type
Use this submenu to change the type or details of the
currently assigned model.
First, turn the receiver system off and turn the trans-
mitter's RF module off. From the main display, press
the BASE menu gear icon (green "B") to bring up the
BASE submenu screen:
000%
000:00.0
000 000
mz
000:00.0
0:01:23
Press
M - 1
000 000
PHASE 1
MODELLNAME 1
BATT TIME 00: 01: 23
000
From the BASE submenu display, press the Model
Type icon:
BACK BASE FUNCTION
Model Sel Model Type E.P.A REV/SUB
TX ctl Timer Fail Safe Trim Step
Press
CTL Set Out.Swap Telemetry Announce
If the receiver is still powered and connected to the
transmitter, the following Active Warning message will
appear:
BACK BASE FUNCTION
Warning
Model Sel MODELLTYP WEG/LIM UMK/MITTE
Switch OFF the receiver First
OK
TX ctl UHREN FAIL-SAFE TR.ST.
CTL Set Telemetry
Out.Swap Announce
Press OK, turn the receiver off and press the Model
Type icon again.
60 Base menu - Model type
The information screen for the currently active model
will appear:
000%
4.2V
The basic model type is assigned when creating a
new model memory in the BASE submenu Model Sel.
In the BASE submenu Model Type, it is possible to
change the model type of the current model. When
000
such a change is made, all of the mixers, coupling
functions, etc. for the previous model type are deleted
or need to be adapted to the changed type.
SYSTEM
Notice
Once you change any of the existing settings, all
of the relevant parameters are reset.
THR.CUT
Servo
Programming
In the following example, the Model Memory 01 is
currently assigned to an airplane but needs to be
changed to a helicopter. Begin by pressing the model
type icon:
SYSTEM
Motor
Servo
BACK
M/TYPE W/TYPE P/TYPE
NORMAL
1A
T/TYPE
AIRPLANE ELE.POWER
NORMAL
BACK BACK
M/TYPE M/TYPE W/TYPE W/TYPE P/TYPE P/TYPE
NORMAL NORMAL
1A 1A
T/TYPE T/TYPE
AIRPLANE AIRPLANE ELE.POWER ELE.POWER
NORMAL NORMAL
Touch
Press
The safety message "SURE?" appears:
BACK SURE? OK
HELICOPTER AIRPLANE GLIDER
CAR COPTER
NO
Press to terminate the procedure or press
to proceed. The OK button will highlight blue for one
second. Make the new model type choice as soon as
the OK button changes back to black.
Press the HELICOPTER icon:
BACK SURE? OK
HELICOPTER AIRPLANE GLIDER
Press
CAR COPTER
The display changes to the next selection screen for
that model type:
Refer to the section New Model Basic Settings -
MANUAL (page 42) for further information on manu-
ally setting new models.
BOAT
OK
BOAT