D/R,Exp - GRAUPNER mz-24 Pro Programming Manual

D/R,EXP
Control Attitude Settings for Control Functions 2, 3 and 4
The dual rate/expo function allows users to assign
switches and phases to change or influence the con-
trol deflections and characteristics of channels 2, 3
and 4.
To change these settings, from the main display press
the FUNCTION menu gear icon (blue "F") to bring up
the FUNCTION submenu screen:
000%
000:00.0
000 000
mz
000:00.0
0:01:23
Press
M - 1
000 000
PHASE 1
MODELLNAME 1
BATT TIME 00: 01: 23
000
From the FUNCTION submenu display, press the
D/R,EXP icon:
BACK BASE FUNCTION
Phase

D/R,EXP

THR.CRV Prog.MIX
Press
Logical sw Sequence
This procedure is identical for all models, but the
channel page labeling differs between models. Refer
to the model type to understand the different values in
the field to the right of the CH line.
124 Function menu | general - DR/Expo
For all CARS, BOATS or DRONES, the channel set-
ting pages of this submenu are labeled CH2, CH3 and
CH4, as shown below:
000%
4.2V
000
SYSTEM
For all HELICOPTERS, the channel setting pages of
this submenu are labeled ROLL (CH2), NICK (CH3)
and TAIL (CH4), as shown below:
Trainer
BACK PHASE 1 D/R,EXP SERVO
CH ROLL
INC
D/R +100% +100%
EXP 000% 000% RES
CTL NULL DEC
SYM OFF
For all AIRPLANES or GLIDERS, the channel setting
pages of this submenu are labeled AILE (CH2), ELEV
(CH3) and RUDD (CH4), for aileron, elevator and rud-
der, as shown below:
BACK PHASE 1 D/R,EXP
CH AILE
D/R +100% +100%
EXP 000% 000%
CTL NULL
SYM OFF
Tip
The 7 individual characteristic curve points for control
function CH1 (throttle/brake) can be set in the follow-
ing sections: all models except helicopters FUNCTION
submenu THR.CRV (page 128), and helicopter models
FUNCTION submenu THR.CRV (page 160).
Dual Rate enable the control surface deflection limits
to be changed while still retaining full stick movement,
i.e. 'normal' deflection plus a setting for decreased/
increased deflection limits at full stick movement. D/R
acts independently from functions that associate a
single servo or are actuated thorough a complex mix-
er or coupling function by multiple servos. (Refer to
the BASE submenu CTL Set (page 90) or Definition
of Terms Control Function (page 24) for additional
information.)
The control deflections can be set for each switch
position between 0 and 125% of the normal control
travel.
EXP allows users to adjust the sensitivity of the con-
trol surface deflection around smaller stick move-
ments. For example, the elevators are barely moved
when the stick moves around its central position, but
SERVO
INC
RES
DEC