GRAUPNER mz-24 Pro Programming Manual page 52

Press the WIZ. button to return to the Pitch Curve
display:
WIZ.
CTL MIXER POINT PHASE
Press
SL 1 THR.CRV 3
NONE NONE L
NONE NONE L
NONE NONE L
NONE NONE L
NONE NONE L
Press the WIZ. button again to advance to the Throt-
tle Curve display:
WIZ. NORMAL PIT.CRV
Pitch min. FORWARD
Press
Curve ON
IN –044%
OUT +027%
POINT 2 +044%
ST ON X-axis Y-axis
52 Base menu - Model selection
THR.CRV
The throttle curve can be specified by assigning up to
7 support points, along the entire control stick travel:
3
THR.Limit
1
INC
1
RES
1
DEC
1
1
Support points can be set, changed and deleted in
the same manner as described in the previous Pitch
Curve section. First specify the throttle curve using
TRIM
three points: the two end points "L" and "H", in addi-
tion to the set point "1" in the control center. These
INC
three points harmonize the motor performance curve
with the pitch curve.
DEC
ENT Tip
The value shown to the right of the THR.Limit line indi-
cates the status or the position of the throttle limit.
Refer to the FUNCTION submenu THR.CRV section
(page 160) for additional information about setting
throttle curves.
(Throttle Curve)
WIZ. NORMAL THR.CRV
OFF TRIM
Curve OFF
IN –100% INC
OUT –100%
POINT L –100% DEC
ST OFF X-axis Y-axis ENT
WIZ.
CTL MIXER POINT PHASE
SL 1 THR.CRV 3 3
NONE NONE L 1
INC
NONE NONE L 1
RES
NONE NONE L 1
DEC
NONE NONE L 1
NONE NONE L 1
Notice
The associated controller does not have any ef-
fect if an undefined point is selected (in the basic
version of the relevant curve mixers, only the
points "L" and "H" are set).
Tips
These options and settings directly affect the TRIM
display options found in the FUNCTION submenu
PIT.CRV (page 154).
These options, settings and phase-specific throttle
curve functions can be changed via the FUNCTION
submenu PHASE (page 120).
WIZ.
Press the button again to advance to the Gyro/
Governor display:
Gyr/Gover
Initial basic settings are needed for the gyro and/or
any governor used in the model.
WIZ.
NORMAL Gyr/Gover
Gyro Suppression 000%
Gyro Gain 000%
Governor ACT INH
Governor RATE 050%
Tip
These options, settings and phase-specific values can
be changed via the FUNCTION submenu PHASE (page
120).
(Gyro/Governor)
INC
RES
DEC