Trainer - GRAUPNER mz-24 Pro Programming Manual

Trainer

Dual Transmitter Connection With DSC Cable
An mz-24 Pro HoTT TEACH transmitter can be con-
nected to any suitable PUPIL transmitter, including
transmitters with a classic 35/40 MHz range. Use the
DSC port on the back of the transmitter to establish a
cable-linked trainer system.
To establish these settings, from the main display
press the FUNCTION menu gear icon (blue "F") to
bring up the FUNCTION submenu screen:
000%
000:00.0
000 000
mz
000:00.0
0:01:23
Press
M - 1
000 000
PHASE 1
MODELLNAME 1
BATT TIME 00: 01: 23
000
From the FUNCTION submenu display, press the
Trainer icon:
BACK BASE FUNCTION
Phase D/R,EXP THR.CRV Prog.MIX
Logical sw Sequence
BACK Trainer
CH 1. TEACH CH 7. TEACH CTL
CH 2. TEACH CH 8. TEACH NULL
CH 3. TEACH CH 9. TEACH BIND
CH 4. TEACH CH 10. TEACH OFF
CH 5. TEACH CH 11. TEACH TYPE
CH 6. TEACH CH 12. TEACH RF
Notice
The previous graphic shows the default status of
this submenu. PUPIL control has not been re-
leased; neither has a switch been assigned.
Transmitter Settings - TEACH
The PUPIL-controlled model must be programmed
000%
with all its functions including trimming and any mix-
4.2V er functions in a model memory of the TEACH trans-
mitter. The receiver of the pupil-model must also be
bound to the TEACH transmitter since that receiver
is responsible for controlling the model even in PUPIL
mode.
Transfer up to 12 function inputs (see Definition of
000
Terms, page 24) of the TEACH transmitter to the PU-
PIL transmitter, either individually or in any desired
combination.
The TEACH
SYSTEM
standard control stick function assignment for func-
tion inputs 1 - 4 found in all model types. Function
inputs 5 - 12 are typically free, or open, inputs. Refer
Trainer
to the BASE submenu CTL Set (page 90).
Press
Notice
It does not matter which specific controls are as-
signed to the control function inputs to be trans-
SERVO
ferred to the PUPIL. Inputs can only be assigned
in the BASE submenu CTL Set (page 90) when the
trainer connection is turned OFF.
labeling value field or button follows the
To transfer any of the control function inputs 1 - 12 to
TEACH
the PUPIL, press the button. The inputs will
be assigned as PUPIL :
BACK Trainer
CH 1. PUPIL CH 7. TEACH CTL
CH 2. PUPIL CH 8. TEACH NONE
CH 3. PUPIL CH 9. TEACH BIND
CH 4. PUPIL CH 10. TEACH OFF
CH 5. TEACH CH 11. TEACH TYPE
TEACH CH 12. TEACH RF
CH 6.
Following the standard conventions for model types
Airplane, Glider and Helicopter when assigning con-
trol functions.
Channel Function
1 Motor/airbrake or pitch
2
Aileron or Roll
3 Elevator or Nick
4 Rudder or Yaw
To change between teacher and pupil, a train-
er-switch must be assigned in the value field in the
CTL column, as described in section Control and
Switch Assignment (page 26).
Function menu | general - Trainer
SERVO
141