GRAUPNER mz-24 Pro Programming Manual page 72

5. Activate the range test mode by touching the but-
ton to the right of the RANGE TEST line:
BACK TX ctl
RX1 RX2
12CH OFF
BIND ON/OFF
TX OUT SET SET SET
Press
ON
RF ON/OFF RF TYPE
OFF
RANGE TEST 99sec
PPM10
DSC OUTPUT AUTOLOG
The following active safety warning appears:
BACK TX ctl
RX1 RX2
12K Select AUS
Bind ON/OFF
TX OUT SET Start range test? SET SET
EIN YES NO
RF ON/OFF HF-Typ
OFF
RANGE TEST 99sec
DSC OUTPUT PPM10 AUTOLOG
Touch NO to terminate the procedure. Touch
to start the range test.
When the range test starts, the output of the trans-
mitter decreases significantly and the Graupner
logo below dials DV2 and DV3 will flash.
72 Base menu - Transmitter setting
Simultaneously, the time display in the transmit-
ter display starts to count backwards and emits 2
beeps every 2 seconds.
NORMAL
OFF
5 seconds before the range test ends, 3 beeps are
emitted every second. After the 99-second range
test, the transmitter switches back to full output,
and the Graupner logo shines continuously.
6. During the range test, move away from the model
NORMAL
while moving the transmitter's control elements. If
you detect an interruption in the link within a range
OFF
of about 164 ft (50 m) at any time, attempt to re-
produce it.
YES
7. If the model has a motor, turn it on to check inter-
ference resistance.
8. Move further away from the model until it does not
respond perfectly.
9. Wait at this location for the remainder of the test
period. The model should still react properly to
control commands once the range test is finished.
If this is not always the case, do not use the sys-
tem and contact the Graupner Service Center.
10. Perform a range test before each flight, simulat-
ing all servo movements that could occur during
the flight. In order to guarantee a safe model op-
eration, the range must always be at least 164 ft
(50 m) on the ground.
BACK TX ctl
RX1 RX2
12CH OFF
BIND ON/OFF
TX OUT SET SET SET
ON NORMAL
RF ON/OFF RF TYPE
OFF
RANGE TEST 78sec
OFF
DSC OUTPUT PPM10 AUTOLOG
WARNING
Never start a range test on the transmit-
!
ter during normal model operation!
DSC OUTPUT (Transmitter Modulation)
To set the modulation of your transmitter at the DSC
output, press the button with the current setting in the
DSC OUTPUT line (repeatedly if necessary) until the
desired modulation appears. Four types of modula-
tion are available in this sequence: PPM10, PPM16,
PPM18 and PPM24:
BACK TX ctl
RX1 RX2
OFF
BIND ON/OFF 12CH
SET SET
TX OUT SET
ON
RF ON/OFF RF TYPE
Press
OFF
RANGE TEST 99sec
PPM10 AUTOLOG
DSC OUTPUT
BACK TX ctl
RX1 RX2
12CH OFF
BIND ON/OFF
TX OUT SET SET SET
ON
RF ON/OFF RF-TYPE
OFF
RANGE TEST 99sec
PPM18
DSC OUTPUT AUTOLOG
The selected modulation primarily influences the
bandwidth and the number of available control chan-
nels at the DSC socket for a connected flight simula-
tor or trainer system. If PPM10 is selected, the avail-
able control channels are 1 - 5; with PPM16, channels
1 - 8, with PPM18, channels 1 - 9, and with PPM24,
channels 1 - 12.
NORMAL
OFF
NORMAL
OFF