GRAUPNER mz-24 Pro Programming Manual page 229

Notice
If the telemetry connection is interrupted for lon-
ger than three seconds (and if the transmitter is
not switched off), the last successfully transmit-
ted GPS coordinates are saved in the transmitter's flash
memory drive. This saved data can be read on the GPS
display using the transmitter control buttons by going
back to the main display or navigating to the GPS dis-
play menu.
ESC (Electronic Speed Controller)
BACK NEXT
QUA 100
30.0 70
cur-VOLT-min cur-TEMP-max
0 0 -20
-020°C -020°C
00.0V 00.0V
cur-RPM-max cur-AMP-max
0 0
000000rpm 000000rpm 000.0A 000.0A
This display shows the data from a HoTT compatible
brushless controller connected to the receiver with in-
tegrated telemetry.
The display shows the current and maximum electri-
cal values of the drive, the current and maximum tem-
perature of the controller, and the current and maxi-
mum speed of the motor connected to the controller.
Value Explanation
QUA Signal package quality (in percent) of
data sent from the transmitter arriving
at the receiver
cur-VOLT- In volts:
min
Left side: actual input voltage
Right side: lowest input voltage since
the device has been switched on
cur-
TEMP-
max
cur-RPM-
max
cur-AMP-
CAPACITY
max
00000mAh
60000
-20
30000
Microcopter Display
0
This screen displays the data of a HoTT-compatible
microcopter. The display screen appears after the
electric air, Vario and GPS module screens.
Value
VOLT
Time
mAh
00
km/h
In Celsius:
Left side: current controller tempera-
ture
Right side: maximum controller tem-
perature since the device has been
switched on
In revolutions per minute:
Left side: current motor speed
Right side: maximum motor speed
since the device has been switched on
In amps:
Left side: Momentary current
Right side: maximum current since the
device has been switched on
BACK NEXT R - 58dB
VOLT 00.0V ALT 0000m
TIME 00:00 DIR 000
mAh 0000 CUR 000.0A
00 00000m
000kmh 000
Explanation
Actual voltage
Time device has been active
Battery charge used since the device
has been turned on
Satellite position number
Above-ground speed (in kilometers per
hour) calculated by the GPS system
ALT Current altitude relative to starting
location
DIR Direction of movement
CUR Momentary current (in amps)
m Distance (in meters) from the starting
location calculated by the GPS system
000 Position (in angular degrees) relative to
the starting location calculated by the
GPS system
Messages from the microcopter sensor are displayed
in the bottom line of the display.
Telemetry data display 229