GRAUPNER mz-24 Pro Programming Manual page 117

• Automatic Sequential
If switches assigned to the REPEAT and TRIGGER
lines are activated, all the announcements includ-
ed in this menu and its submenus will be repeat-
ed within the time interval selected in the REPEAT
line:
BACK Telemetry
REPEAT 10s SW 2 TONE AUTO
TRIGGER SW 3 VARIO NULL
>> >>
TRANSMITTER RECEIVER
GENERAL MOD >> ELEC MOD >>
>> >>
VARIO MOD GPS MOD
>>
ESC MOD
VARIO
If the SENSOR submenu VARIO line is
113), the switches assigned to this line can be used
to retrieve vario-specific voice triggers such as "slow-
ly ascending/descending" through the transmitter's
headphones independent of the other voice triggers,
i.e., voice triggers triggered by a change in height.
BACK Telemetry
REPEAT 10s NULL TONE AUTO
TRIGGER NULL VARIO NULL
>> >>
TRANSMITTER RECEIVER
Press
>> >>
GENERAL MOD ELEC MOD
VARIO MOD >> GPS MOD >>
>>
ESC MOD
Refer to the Control and Switch Assignment section
(page 26) for information on how to assign switches.
TRANSMITTER
Press the bracket button in the TRANSMITTER line:
BACK
REPEAT
TRIGGER
TRANSMITTER
GENERAL MOD
VARIO MOD
ESC MOD
INC
The transmitter display opens:
RES
DEC
BACK
TX-VOLT
MODELTIME
ON (page
BATT TIME
TIMER 1
Use this submenu to activate and deactivate the voice
triggers available for each selection in the value fields:
BACK
TX VOLT
MODELTIME
INC
Press
BATT TIME
RES
TIMER 1
DEC
Telemetry
10s NULL TONE AUTO
NULL VARIO NULL
>> >> INC
RECEIVER
>> >>
ELEC MOD RES
Press
DEC
>> GPS MOD >>
>>
Telemetry
TIMER 2
CURR. TIME
Telemetry
TIMER 2
CURR. TIME
RECEIVER
Press the bracket button in the RECEIVER line:
BACK
Telemetry
REPEAT 10s NULL TONE AUTO
TRIGGER NULL VARIO NULL
TRANSMITTER >> RECEIVER >>
>> >>
GENERAL MOD ELEC MOD
Press
>> >>
VARIO MOD GPS MOD
ESC MOD >>
The receiver display opens:
BACK Telemetry
TEMP
STRENGTH
RX VOLT
L-VOLT
Use this submenu to activate and deactivate the voice
triggers available for each selection in the value fields.
Sensors
The displays for selecting sensor-specific voice trig-
gers should only be opened when the sensors con-
nected to the receivers are recognized after the re-
ceiver is switched on. Three corresponding voice
triggers are selected as described above.
Function menu - Telemetry | Voice Trigger
INC
RES
DEC
117