GRAUPNER mz-24 Pro Programming Manual page 138

• OFFSET X
A value unequal to 000% entered in the OFFSET
X line causes the offset to shift horizontally by a
maximum of ±100%.
In the following example, the offset point needs to
be moved 30% to the right. Press the value field in
the OFFSET X line:
BACK PHASE 1 Prog.MIX
>> CH3 TRIM ON
CH1
ACT ON CTL ON
A +050% B +125%
OFFSET X 000%
OFFSET Y 000%
Press
SYM OFF
The field highlights blue:
BACK
PHASE 1 Prog.MIX
>>
CH1 CH3 TRIM ON
ACT ON CTL ON
A +050% B +125%
OFFSET X 000%
OFFSET Y 000%
SYM OFF
Press the INC button or the up arrow key ( p ) to
move the offset point 30% to the right of the cur-
rently set mixer end point:
BACK
PHASE 1 Prog.MIX
CH1 >> CH3 TRIM ON
ACT ON CTL ON
A +050% B +125%
OFFSET X +030%
000%
OFFSET Y
SYM OFF
138 Function menu | general - Free mixer
Press the RES
back to the default.
• OFFSET Y
A value unequal to 000% entered in the OFFSET Y
line causes the offset to shift vertically by a maxi-
mum of ±100%.
In the following example, the offset point needs
to be moved 50% to the bottom. Press the value
SERVO
field in OFFSET Y line:
BACK
INC
CH1
RES
DEC
SERVO
The field highlights blue:
BACK
INC
CH1
RES
DEC
Next, press the
key ( q ) to move the offset point 50% below the
SERVO
currently set mixer point:
BACK
INC
CH1
RES
DEC
button to reset the changed value
SERVO
PHASE 1 Prog.MIX
>> CH3 TRIM ON
ACT ON CTL ON
A +050% B +125% INC
Press
OFFSET X +030% RES
000% DEC
OFFSET Y
SYM OFF
SERVO
PHASE 1 Prog.MIX
>> CH3 TRIM ON
ACT ON CTL ON
A +050% B +125% INC
OFFSET X +030% RES
DEC
OFFSET Y 000%
SYM OFF
DEC button or the down arrow
PHASE 1 Prog.MIX SERVO
>>
CH3 TRIM ON
ACT ON CTL ON
INC
A +050% B +125%
RES
OFFSET X +030%
DEC
OFFSET Y –050%
SYM OFF
Press the RES button to reset the changed value
back to the default.
Attention
The curve shown above is for demonstration
purposes only and does not represent an ac-
tual mixer guide line.
Mixer Switch
Once a mixer is activated, the value fields in the ACT
and CTL lines automatically change to
activates the relevant mixer and turns it on perma-
nently in the current phase. Refer to the Activating
and Deactivating Mixers section (page 136) for more
information.
Each mixer can be turned on and off by assigning it
a switch that has not been assigned other functions.
Press the value field in the CTL line:
BACK PHASE 1 Prog.MIX
Press
CH1 >> CH3 TRIM ON
ACT ON CTL ON
A +050% B +125%
OFFSET X +030%
OFFSET Y –050%
SYM OFF
ON . This
SERVO
INC
RES
DEC