GRAUPNER mz-24 Pro Programming Manual page 123

Attention
In the helicopter AUTOROT phase, always
leave the standard delay time as 0.0s. For
safety reasons, if a switchover is necessary
the phase can be changed immediately and without
delay.
Notice
For all models, the switchover time set here
acts uniformly across all phase-specific set-
tings and all active mixers. The switchover
between phase-dependent mixers should proceed
smoothly.
• CTL Column
Use this function to change between phases.
Press the field for the appropriate phase in the CTL
column:
BACK SET
PHASE
PHASE SLOW CTL
1. NORMAL 1.2s
2. START 0.0s NULL
3. PHASE 3
Press
4. PHASE 4
5. PHASE 5
An active display pops up:
1.
2.
3.
4.
5.
Press NO
to clear any existing values. Press
assign a switch to perform this function. Refer to
Control and Switch Assignment section (page
26) for more information on assigning switches.
Notices
• NORMAL/Phase1 is the default when
none of the assigned phase switches are
in the ON position.
• To avoid function errors, never assign a
switch to both a User Voice Recording and
(Control/Switch)
a Phase function.
• SET Button
To assign individual voice announcements to the
different phases, press the
NEXT
per right of the display:
NEW
NAM
CPY
DEL
INC
DEC
BACK PHASE SET NEXT
PHASE SLOW CTL NEW
Select
NORMAL 1.2s NAM
NO
START 0.0s NULL CPY
CLR
PHASE 3 DEL
LOGIC
INC
PHASE 4
PHASE 5 DEC
to terminate the process. Press
LOGIC to
SET button at the up-
BACK PHASE SET NEXT
PHASE SLOW CTL NEW
Press
1. NORMAL 1.2s NAM
2. START 0.0s NULL CPY
3. PHASE 3 DEL
INC
4. PHASE 4
5. PHASE 5 DEC
The following display appears:
BACK PHASE 1
PH. VOICE 1
PH. VOICE 2
PH. VOICE 3
PH. VOICE 4
PH. VOICE 5
PH. VOICE 6
Press to highlight the appropriate phase voice val-
CLR
ue field. Scroll through the list of available voice
announcements by pressing the
buttons at the right edge. Press the
to clear any selection. In the example below, Voice
Announcement #254 has been selected:
BACK
PHASE 1
PH. VOICE 1
PH. VOICE 2
PH. VOICE 3
PH. VOICE 4
PH. VOICE 5
PH. VOICE 6
Press the BACK button at the top left of the dis-
play to return to the main Phase display.
Function menu | general - Phase
Phase
INC
RES
DEC
INC or DEC
RES button
Phase
254_Normal_22k
INC
RES
DEC
123