Model Type - GRAUPNER mc-26 Programming Manual

Model type

Suppress models
Base setup model
Model type
Ser vo adjustment
Stick mode.
Control adjust
M o d e l t y p e
Motor at C1 None
Leitwerk nor mal
Querr./Wölb
Bremsoffs. +100%
33028_mc_28_Teil2_jh
In this menu you can adjust the settings for the actual model type.
Here you can select for example the tail and wing type or whether
the model has motor or not.
If in the model selection you have chosen copter, car or boat in this
menu will appear only the line "Motor at CH1". Here you have the
following selection possibilities:
1QR
Ein1
"None"
SEL
You are using a model without drive. The warning "Throttle too
high!" is deactivated and the sub-menu "Brake settings" of the "Wing
mix" menu is available.
"Backward"
The idle position of the Throttle/Airbrakes control stick (CH1) is in
the backward position, in the pilot direction. The warning "Throttle
too high!" so as the "Throttle cut" option of the "Model base set-
tings" menu are active.
"Forward"
The idle position of the Throttle/Airbrakes control stick (CH1) is in
the forward position, in the opposite direction of the pilot. The warn-
ing "Throttle too high!" and the "Throttle cut" option of the "Model
base settings" menu are active.
Note
The CH1 trim acts accordingly to your selection "normally" or only
"backward" or "forward", then through the entire control travel or
only in the related idle direction.
Please pay attention to the "Switch-off trim" function described in
the "Digital trim" section.
25 / 80