Announce - User Voice Recordings - GRAUPNER mz-24 Pro Programming Manual

Announce
User Voice Recordings
To change the voice recording settings, from the main
display press the BASE menu gear icon (green "B") to
bring up the BASE submenu screen:
000%
000:00.0
000 000
mz
000:00.0
0:01:23
Press
M - 1
000 000
PHASE 1
MODELLNAME 1
BATT TIME 00: 01: 23
000
From the BASE submenu display, press the An-
nounce icon:
BACK BASE FUNCTION
Model Sel Model Type E.P.A REV/SUB
Press
TX ctl Timer Fail Safe Trim Step
CTL Set Out.Swap Telemetry Announce
Saved in the mz-24 Pro HoTT transmitter memory,
near the datafiles for the other transmitter announce-
ments, are the User-Voice-Files, numbered from
285 to 294. These special announcements can be
replaced by user-created .wav files via the Firmware_
Upgrade_grStudio. All voice files can be assigned as
phase-specific or phase-crossing in the BASE sub-
menu Announces.
118 Base menu - Announces
Phase Depending Settings
This submenu allows for different phase-specific val-
ues to be programmed. Phase names are displayed
000% in green in the upper left side of the screen next to
the BACK button. Standard default naming for the
4.2V
phases are usually displayed as NORMAL/PHASE
1. (Additional phases will be named numerically, e.g.
Phase 2, Phase 3, etc.) To define multiple phases,
refer to the FUNCTION submenu Phase section (page
120). Each new phase will need to be assigned to a
different switch. To change the phases, activate the
000
corresponding switch(es).
CTL Column
Use this column to assign a switch to the announce-
ment:
SYSTEM
THR.CUT
1.
2.
Servo
3.
4.
5.
Refer to the Control and Switch Assignment section
(page 26) for information on how to assign switches.
Notices
Free switch assignment is only possible when the
value field of the PHASE column is CO. When the
PHASE value is SE, only switches that are not
already assigned to a model memory phase will be avail-
able. This prevents error functions.
BACK SERVO
PHASE 1 Announce
CTL PHASE ANNOUNCEMENT
SW 3 CO NEXT
INC
NULL CO
NULL CO RES
DEC
NULL CO
NULL CO
PHASE Column
In this column changes between CO (common), model
memory specific, and SE (single), phase specific an-
nounce. Press the value field of the value to change:
BACK
PHASE 1 Announce
ANNOUNCEMENT
CTL PHASE
1. SW 3 CO
2. NULL CO
Press
3.
NULL CO
4. NULL CO
5. NULL CO
BACK
PHASE 1 Announce
CTL PHASE Announcement
1. SW 3 SE
2. NULL CO
3. NULL CO
4. NULL CO
5. NULL CO
ANNOUNCEMENT Column
Use this column to activate, according to the switch
position and phase, a User_Voice announcement.
Press the value field in the ANNOUNCEMENT col-
umn:
BACK
PHASE 1 Announce
Press
CTL PHASE Announcement
1. SW 3 SE
2. NULL CO
3. NULL CO
4. NULL CO
5. NULL CO
The field highlights blue:
SERVO
NEXT
INC
RES
DEC
SERVO
NEXT
INC
RES
DEC
SERVO
NEXT
INC
RES
DEC