GRAUPNER mz-24 Pro Programming Manual page 100

Specifically, there is the possibility of back-channels re-
ciprocal interference, e.g. a camera drone with separate
camera and drone control or a towing model for mod-
el-parachute.
Scroll between the individual Telemetry menu pages
ENT
by pressing the (forward) and
buttons. Angled brackets ">" and "<" will appear on
the RX line indicating the direction of additional pag-
es:
BACK
Telemetry
RX SERVO V6.35<> RECV
>OUTPUT CH : 01
GAM
REVERSE : OFF
CENTER : 1500µsec EAM
TRIM : –000µsec
VARIO
LIMIT– : 150%
LIMIT+ : 150% GPS
PERIOD : 20msec
ESC
If only one angled bracket is showing, this indicates
the first or final menu page; scroll only in the direction
indicated.
To change parameters on a menu lines, move the
left-hand line bracket (seen above to the left of the
OUTPUT CH line). Press the INC
move the ">" pointer up or down one line. The brack-
et will automatically skip menu lines which cannot be
changed.
To change a parameter, place the pointer on the menu
line and press the SET button at the right edge of
the screen. The parameter to be changed highlights
white:
BACK
Telemetry
RECV
RX SERVO V6.35 < >
OUTPUT CH : 01
GAM
REVERSE : OFF
EAM
> CENTER : 1500µsec
TRIM : –000µsec
VARIO
LIMIT– : 150%
LIMIT+ : 150% GPS
PERIOD : 0msec
ESC
100 Function menu - Telemetry
Press the INC
within the selected range. Press the
confirm and store to the receiver memory.
Press the ESC
to return to the previous page; press the
ton at the top left of the Telemetry display to return to
ESC
(reverse)
the BASE submenu screen:
ESC
DEC
INC
ENT
SET
Notices
• If an active warning message appears instead
of the desired Telemetry page menu, then
there is no connection with the receiver. Turn
on the receiver system, bind the receiver or
activate it in the RX SELECT line as described
above in the Basic Operation section (page
99).
or DEC button to
• If an active warning message appears un-
expectedly while the Telemetry page menu
is being programmed, the connection to the
receiver system has been suddenly lost. Turn
the receiver system off and on again, or find
the origin of the connection failure, or re-bind
the receiver.
ESC
DEC
INC
ENT
SET
or DEC buttons to change the value
SET
button to
button at the top right of the display
BACK
BACK Telemetry
RX SELECT RX1 ALWAYS
>>
SETTING & DATA VIEW
>> INC
SENSOR
RF STATUS VIEW >> RES
>> DEC
VOICE TRIGGER
but-