GRAUPNER mz-24 Pro Programming Manual page 140

are automatically renumbered sequentially from left to
right after points are set or deleted.
Deleting a Support Point
To remove a set support point, move the control stick
until the vertical green line aligns with the point to be
deleted. The support point will turn red and its number
and associated value will appear in the POINT line. To
clear the point, press the ENT button:
BACK
PHASE 1 Prog.MIX
CH8 >> CH10 TRIM ON
ACT ON CTL ON
IN –085%
OUT 000%
POINT 1
000%
ST ON X-axis Y-axis
The red point disappears:
BACK PHASE 1 Prog.MIX
CH8 >> CH10 TRIM ON
ACT ON CTL ON
IN –085%
OUT 000%
POINT ? 000%
ST ON X-axis Y-axis
Changing the Support Point Value
• X-axis Button
Activate this function, press to highlight the
is button at the bottom edge of the display. Point
values can be changed only when the button is
blue.
Move the active (red) point to the right by pressing
INC
the button or to the left with the
ton. In the example below, Point 1 (set at -45%)
and Point 2 (set at +45%) is moved and placed
precisely between the end position and middle po-
sition:
140 Function menu | general - Free mixer
CH8
Press the X-axis
tion. The button changes back to black.
SERVO
Notices
• Moving the red point horizontally away
INC
from the current control position will cause
the point to become green after a short
Press
DEC
while, and a ? will appear in the Point line.
ENT
This question mark does not relate to the
point which has been moved, rather, it in-
dicates that another point can be set at the
SERVO
current control position.
• Remember that the percentages in the in-
put (IN) and output (OUT) line always refer
INC
to the temporary position of the control
stick and not to the position of the point.
DEC
• Y-axis Button
ENT
Activate this function, press to highlight the
is button at the bottom edge of the display. Point
values can be changed only when the button is
(X-axis)
blue.
X-ax-
Move the active (red) point to the right by pressing
the INC button or to the left with the
ton:
DEC
but-
BACK PHASE 1 Prog.MIX SERVO
>> CH10 TRIM ON
ACT ON CTL ON
INC
IN +050%
OUT 000%
DEC
POINT 2 000%
ST ON X-axis Y-axis ENT
button to deactivate the func-
(Y-axis)
Y-ax-
DEC
BACK PHASE 1
CH8 >> CH10
ACT ON
IN
OUT
POINT
ST ON
Press the Y-axis button to deactivate the func-
tion. The button changes back to black.
Notice
Remember that the percentages in the input
(IN) and output (OUT) line always refer to the
temporary position of the control stick and not
to the position of the point.
Press the BACK button at the top left of the display
to return to the mixer selection.
BACK BASE
Phase D/R,EXP THR.CRV
Logical sw Sequence
but-
Prog.MIX SERVO
TRIM
ON
CTL ON
INC
+050%
+050%
DEC
2 +050%
X-axis Y-axis ENT
FUNCTION SYSTEM
Prog.MIX Trainer