GRAUPNER mz-24 Pro Programming Manual page 113

SENSOR SETTINGS and DISPLAYS
If one or more sensors are connected to a receiver
and a telemetry link exists with this receiver, retrieve
the sensor display and change its settings in the RX
SERVO TEST screen (page 109).
Tip
The mz-24 Pro HoTT transmitters automatically recog-
nize any sensor(s) connected to a switched on receiver
or sensor(s) that have been connected after the power
supply is turned on.
If at least one sensor connected to the telemetry re-
ceiver and it has firmware from the same Vx firmware
package as the receiver, change directly between the
individual devices by pressing a selection button.
• The abbreviations on the selection buttons stand
for the following:
RECV = Receiver
GAM
= General Air Module
EAM = Electric Air Module
VARIO = Vario Module
GPS = GPS Module
ESC
= Electronic Speed Controller
Press to highlight the selection button:
BACK
Telemetry
RECV
RX SERVO TEST V6.35 <
>ALL-MAX : 2000µsec
GAM
ALL-MIN : 1200µsec
EAM
TEST : STOP
ALARM VOLT : 3.8V
Press
VARIO
ALARM TEMP+ : 55°C
ALARM TEMP– : –10°C GPS
CH OUT TYPE : ONCE
ESC
The field highlights blue:
BACK
RX SERVO TEST
>ALL-MAX
ALL-MIN
TEST
ALARM VOLT
ALARM TEMP+ : 55°C
ALARM TEMP– : –10°C
CH OUT TYPE : ONCE
If a sensor was recognized by the receiver after it
was turned on, an angled bracket ( ) appears. Press
the ENT button and check or change its settings as
described in the instructions that came with the sen-
sor.
ESC
DEC
INC
ENT
SET
Telemetry
RECV ESC
V6.35 <
: 2000µsec
GAM DEC
: 1200µsec
: STOP EAM INC
: 3.8V
VARIO ENT
GPS
SET
ESC
SENSOR
Active/Inactive Sensor Display
To open the sensor submenu, press the button in the
SENSOR line:
BACK Telemetry
RX SELECT RX1
>>
SETTING & DATA VIEW
>>
SENSOR
>>
RF STATUS VIEW
Press
>>
VOICE TRIGGER
Notice
The mz-24 Pro HoTT transmitters automatically
recognize any sensor(s) connected to a switched
on receiver or sensor(s) that have been connect-
ed after the power supply is turned on.
BACK
Telemetry
RECEIVER ON
GAM ON
EAM OFF
VARIO OFF
GPS ON
ESC OFF
In this submenu, active or inactive sensors are auto-
matically labeled as ON or OFF, provided that a te-
lemetry link exists. Manual sensor selection is then
unnecessary and impossible.
Base menu - Telemetry | SETTINGS/DISPLAYS
ALWAYS
INC
RES
DEC
113