GRAUPNER mz-24 Pro Programming Manual page 190

The field highlights blue:
BACK PHASE 1 WING MIX
AILE >> RUDD
A RATE B
+100% +100%
Press the INC or DEC buttons or the arrow keys
( pq ) to increase/decrease the value.
Use the same procedure to adjust the other values.
In the example below, RATE B now needs to be set
at +50%:
BACK PHASE 1 WING MIX
AILE >> RUDD
A RATE B
+050% +050%
RES
Press the button to reset the changed value
back to the default.
Tip
Bring up the servo monitor in one of three ways: press-
ing the SERVO button in the upper right corner of the
display, by simultaneously pushing both arrow keys
( pq ), or by pressing the BASE submenu Servo icon.
To exit the Servo display, press the
push the ESC key to return to the previous menu.
190 Function menu | Airplane models - Airplane mixer
To save and exit, press the
left of the display to return to the previous menu:
SERVO
AILE >> RUDD
INC
RES
DEC
The main Wing MIX display appears:
RUDD >> AILE
SERVO
AILE >> RUDD
RUDD >> ELEV
INC
RES
RUDD >> ELEV Line
DEC
In aerobatic flight, the behavior of the latitude axis is
influenced when the rudder is actuated. This is par-
ticularly problematic in "knife edge flying" since the
wings are vertical in this flight position and the only
lift is from the fuselage when the rudder is deflected.
Changes in direction can occur as if the elevator were
actuated. When the rudders are controlled, a correc-
tion is necessary along the transverse axis (elevator)
within an adjustable range.
BACK button or The rudder and elevator remain independently con-
trolled.
The setting range of ±150 % makes it possible to ap-
propriately adapt the deflection direction. This mixer
can be turned on and off so that the model can be
used exclusively via the rudder. Turn mixer off with a
control (which cannot be independently reset), a con-
trol switch or a logical switch.
BACK button at the top
BACK PHASE 1 WING MIX SERVO
Press
A RATE B
+050% +050% INC
RES
DEC
BACK PHASE 1 WING MIX SERVO
MIX.TYPE ACT SET CTL
>>
ON SW 6
>>
ON SW 8
>>
INH ON
(Rudder >> Elevator)
To set the mixer, press the >> button in the RUD-
D>>ELEV line:
BACK PHASE 1 WING MIX
MIX.TYPE ACT SET CTL
RUDD >> AILE ON >>
SW 6
>>
AILE >> RUDD ON SW 8
>>
RUDD >> ELEV INH ON
Press
The RUDD>>ELEV setting display opens:
BACK PHASE 1 Wing MIX
RUDD >> ELEV
A RATE B
+100% +100%
Press the desired value field. In the example below,
RATE A needs to be at +50%:
BACK PHASE 1 Wing MIX
RUDD >> ELEV
A RATE B
+100% +100%
Press
SERVO
SERVO
INC
RES
DEC
SERVO
INC
RES
DEC