Sequence - Sequencer - GRAUPNER mz-24 Pro Programming Manual

Sequencer
Logical Switch Setup
A sequence allows up to three servos to perform up to
nine steps during a 30-second period. For example,
sequencing can allow the cover doors to open while
folding landing gear descends the fuselage, then close
again when the landing gear leg has extended. Alter-
natively, sequencing can allow the canopy to open,
the pilot turn his head and wave his hand. All of these
actions must first be divided into a logical sequence
of single movements.
To set a sequence, from the main display press the
FUNCTION menu gear icon (blue "F") to bring up the
FUNCTION submenu screen:
000%
000:00.0
000 000
mz
000:00.0
0:01:23
Press
M - 1
000 000
PHASE 1
MODELLNAME 1
BATT TIME 00: 01: 23
000
From the FUNCTION submenu display, press the Se-
quence icon:
BACK BASE FUNCTION
Phase D/R,EXP THR.CRV Prog.MIX
Logical sw Sequence
Press
BACK
Sequence
CH9 INH CH10 INH CH11
STEP
0
CTL
NULL
TIME 00.0s POS 000
150 Function menu | general - Sequencer
Through the Sequence display, one common switch
can be assigned to activate up to three servos per-
forming up to 9 precisely determined steps within 30
seconds.
Selection and Control Channel Activation
• Channel Selection
The three pre-set channels CH9, CH10 and CH11
can be changed by pressing the value field:
000% Press
4.2V
The field highlights blue. Press the
button or the arrow keys ( pq ) to scroll through
the available channels (5 - 12). In the example be-
000
low, the default CH9 field is changed to CH6:
SYSTEM
Trainer
Use the same procedure with the other channel
value fields.
SERVO
Press the
INH
back to the default.
INC
RES
DEC
BACK Sequence SERVO
CH9 INH CH10 INH CH11 INH
STEP
INC
0
CTL RES
DEC
NULL
TIME 00.0s POS 000
INC
or
BACK SERVO
Sequencer
CH6 INH CH10 INH CH11 INH
STEP
0 INC
CTL RES
NULL DEC
TIME 00.0s POS 000
RES button to reset the changed value
• Activation / Deactivation
The control channels specifically required for the
channel sequencing are activated and deactivat-
ed by pressing the INH
nel fields to change to
example below, all channels have been changed
to ON:
BACK
CH6 ON CH7
TIME 00.0s POS
Notice
All control functions activated in the FUNC-
DEC
TION submenu Sequence are unavailable for
other uses.
Sequencing
• STEP 0: Setting the Output Position
The output position can be activated in one of two
ways. Press any channel field to highlight the but-
ton blue. The corresponding output position line
highlights green. Or, press any output position
line to highlight green. The corresponding channel
field button highlights blue:
BACK
CH6 ON CH7
Press
Press
TIME 00.0s POS
buttons next to the chan-
ON
and vice versa. In the
Sequence SERVO
ON CH8 ON
STEP
INC
0
CTL RES
DEC
NULL
000
Sequence SERVO
ON CH8 ON
STEP
0 INC
CTL RES
DEC
NULL
000