Display Operation - GRAUPNER mz-24 Pro Programming Manual

Display Operation

Operate the display by pressing value fields or icons
with a finger or the provided stylus:
000%
000:00.0
000 000
mz
000:00.0
0:01:23
M - 1
000 000
PHASE 1
MODELLNAME 1
BATT TIME 00: 01: 23
000
The main menu display has shortcuts and icons that
easily take users to desired menus or information dis-
plays. For example, pressing the model memory field
labeled M-1 in the above display is a shortcut to the
BASE submenu Model Sel:
BACK MODEL NAME 1
01 MODEL NAME 1
02 MODEL NAME 2
03 MODEL NAME 3
04 MODEL NAME 4
05 MODEL NAME 5
06 MODEL NAME 6
Many menus and submenus have additional display
screens or pop-up menus that can be accessed by
pressing the buttons. For example, in the above
screen, highlighting a model name line number and
pressing SEL brings up a pop-up menu for chang-
ing the model saved in that memory line. Conversely,
pressing NEW brings up a pop-up menu allowing
the user to manually setup model names or use the
setup Wizard.
Pressing YES or NO will accept or cancel pop-up
selections.
Pressing BACK returns users to the previous menu
screen. Pressing NEXT advances users to the next
option screen.
6 Operating the displays
To access the BASE, FUNCTION, SYSTEM and TE-
LEMETRY menu screens, press one of the four gear
icons along the bottom of the basic display: the green
000%
"B", the blue "F", the purple "S" or the blue "T". Se-
4.2V
lection menus open from which you can choose relat-
ed submenus.
The BASE submenu selection display
pears as follows:
000
BACK
Model Sel
TX ctl
NEXT
SEL
CTL Set
NEW
IMP.M
The FUNCTION submenu selection display
EXP.M
120) is model-type-specific, and the icons shown will
RES
change depending on which model is being used.
CPY
The submenus are divided into three types: Vehicles/
Drones/Boats, Helicopters, Fixed-Wing. Refer to
the Table of Contents for information on type-specif-
ic functionalities, as the manual divides the Function
menu into thirds according to model differences.
The FUNCTION Vehicle/Drone/Boat menu selection
display appears as follows:
Logical sw
(page 38) ap-
BASE FUNCTION SYSTEM
Model Type E.P.A REV/SUB THR.CUT
Timer Fail Safe Trim Step Servo
Out.Swap Telemetry Announce
(page
BACK BASE FUNCTION SYSTEM
Phase D/R,EXP THR.CRV Prog.MIX Trainer
Sequence
The FUNCTION Helicopter menu selection display
appears as follows:
BACK BASE FUNCTION
Phase D/R,EXP PIT.CRV THR.CRV
THR.HOLD Swash S.Limit S.MIX
Prog.MIX Trainer PIT>>TAIL Logical sw
The Fixed-Wing models are further divided into two
additional screens. The FUNCTION Motor-Powered
menu selection display appears as follows:
BACK BASE FUNCTION
Phase D/R,EXPO THR.CRV Idle LOW
Snap roll Aile diff Wing MIX Flap MIX
Airbrake TTrainer Logical sw Sequence
And the FUNCTION Glider menu selection display
appears as follows:
BACK BASE FUNCTION
Phase D/R,EXP THR.CRV Prog.MIX
Aile diff Wing MIX Flap MIX Flap set
Trainer Logical sw Sequence V-Tail
SYSTEM
Gyr/Gover
THR.MIX
Sequence
SYSTEM
Prog.MIX
Flap set
V-Tail
SYSTEM
Snap roll
Butterfly