GRAUPNER mz-24 Pro Programming Manual page 50

Tip
Remember that the input/output percentages in
the IN and OUT lines always refer to the momen-
tary position of the control stick and not to the
position of the point.
Rounding Off the Throttle Curve
• Curve Line ON/OFF Button
The default angled curve profile can be au-
tomatically rounded off by turning on the
rounding function by pressing the
button in the Curve line, as shown below:
WIZ. NORMAL PIT.CRV
Pitch min. FORWARD
Curve OFF
IN –044%
Press
OUT +027%
POINT 2 +044%
ST ON X-axis Y-axis
PIT.CRV
WIZ. NORMAL
Pitch min. FORWARD
Curve ON
IN –044%
OUT +027%
POINT 2 +044%
ST ON X-axis Y-axis
Notice
The curves portrayed here are for demon-
stration purposes only and do not repre-
sent real pitch curves.
50 Base menu - Model selection
• TRIM Button
The mz-24 Pro transmitter software has a
function that is integrated in the helicopter pro-
gram for trimming during flight up to six sup-
port points of the two options "throttle curve"
and "pitch curve".
Open the following window by touching
the TRIM
display:
WIZ.
ON/OFF CTL
NONE
NONE
NONE
NONE
TRIM
NONE
NONE
INC
Basic Operating Steps
DEC
• CTL Column
ENT
Use the first column to select a control that
appears suitable for the controls offered by
the transmitter.
TRIM
To assign a control, press the button in the
CTL column along the appropriate row:
INC
WIZ.
DEC
CTL
ENT
NONE
NONE
Press
NONE
NONE
NONE
NONE
An active warning window will appear:
button at the top right edge of the
MIXER POINT PHASE
NONE L 1
NONE L 1
INC
NONE L 1
RES
NONE L 1
DEC
NONE L 1
NONE L 1
MIXER POINT PHASE
NONE L 1
Select
NONE KEIN 1
INC
NO
NONE KEIN 1
RES
NONE KEIN CLR 1
DEC
NONE L 1
NONE L 1
WIZ.
CTL MIXER POINT PHASE
NONE NONE L 1
Select
NONE NONE KEIN 1
INC
NO
NONE NONE KEIN 1
RES
CLR
NONE NONE KEIN 1
DEC
NONE NONE L 1
NONE NONE L 1
Press to scroll through the control options.
In this example, the right proportional rotary
control SL1 is selected:
WIZ.
CTL MIXER POINT PHASE
SL 1 NONE L 1
NONE NONE L 1
INC
NONE NONE L 1
RES
NONE NONE L 1
DEC
NONE NONE L 1
NONE NONE L 1
• MIXER Column
Use the second column to select individu-
al helicopter mixers, or one of the two avail-
able mixers in any combination.
To select a mixer, press the button in the
MIXER column along the appropriate row:
WIZ.
CTL MIXER POINT PHASE
SL 1 NONE L 1
NONE NONE L 1
INC
Press
NONE NONE L 1
RES
NONE NONE L 1
DEC
NONE NONE L 1
NONE NONE L 1
The button will highlight blue: