GRAUPNER mz-24 Pro Programming Manual page 99

• To avoid accidental starts, models and
sensors should only be programmed
when the model is on the ground with
the motor turned off or the drive bat-
tery disconnected.
For example, a servo test that acci-
dentally activates the receiver could
cause the model to crash and cause
injury or property damage.
• Consult the safety instructions con-
tained in the Part 1 of the manual in-
cluded in the transmitter packaging.
Telemetry
To change the telemetry settings, from the main dis-
play press the BASE menu gear icon (green "B") to
bring up the BASE submenu screen:
000%
000:00.0
000 000
mz
000:00.0
0:01:23
Press
M - 1
000 000
PHASE 1
MODELLNAME 1
BATT TIME 00: 01: 23
000
From the BASE submenu display, press the Teleme-
try icon:
BACK BASE FUNCTION
Model Sel Model Type E.P.A REV/SUB
Press
TX ctl Timer Fail Safe Trim Step
CTL Set Out.Swap Telemetry Announce
BACK
Telemetry
RX SELECT RX1 ALWAYS
>>
SETTING & DATA VIEW
SENSOR >>
>>
RF STATUS VIEW
>>
VOICE TRIGGER
Basic operation
The Telemetry menu corresponds to the other menus
of the mz-24 HoTT Pro transmitter; the few deviations
are described below:
If you have bound a receiver as RX1 or RX2 in the
BASE submenu TX ctl, then designate one of the two
receivers as the "telemetry-receiver" by changing the
value of the field to the right of
LECT line. It is standard practice to default to the
000%
most recent receiver bound. To change the default
4.2V
setting ALWAYS , press to highlight the field blue:
000
SYSTEM Press the INC
the display to change the value. Alternatively, press
the arrow keys ( pq ) to the left of the display screen
THR.CUT
to achieve the same result.
RES
Press the
Servo
back to the default (ALWAYS).
Value
ALWAYS
4TIME
INC
8TIME
RES
DEC
OFF
Notice
Using settings other than the
only suggested if two non-connected receivers
are bound to two different transmitters for close
distance use, as the back-channel of one of the two re-
ceivers is often disrupted.
RX1 in the RX SE-
BACK
Telemetry
RX SELECT RX1 ALWAYS
SETTING & DATA VIEW >>
>>
SENSOR INC
>>
RF STATUS VIEW RES
VOICE TRIGGER >> DEC
or DEC button at the right edge of
button to reset the changed value
Explanation
The transmitter reacts to the
back-channel of the selected receiver
with normal/standard functionality.
The transmitter reacts to the
back-channel of the selected receiver
with the selected delay.
The transmitter telemetry functions
are turned off.
ALWAYS
default is
Function menu - Telemetry 99