Swash Type
Only When the Helicopter Type has been Selected
When using a helicopter that incorporates a CCPM system,
this function automatically carries out the mixing operation
of the servos connected to the swash plate.
Selection should be carried out that matches the helicopter
body that is to be used.
It will be possible to select from 1-servo (Non-CCPM type
helicopter), 2-servo (180° interval type), 3-servo (120°,
140°, and 90° interval type), and 4-servo (90° interval type).
After selecting the Type in this function, detailed setting
should be carried out using Swash Mixing (Function Mode).
(Pitch)
When the 3-servo 120° type has been selected.
When the 3-servo 90° type has been selected.
(System Setting Mode)
Initial Condition
This is set to 1-servo (Normal).
Swash Type Selection Screen
(Aileron)
(Elevator)
(Pitch)
(Aileron)
(Elevator)
Setting Method
By rotating the dial to highlight the Type display part, then
pressing the dial, a list will be displayed. Rotate the dial to
highlight the Type that you wish to select and press the dial
to determine the Type, which will change the Type display.
Swash Type
(Pitch)
(Elevator)
When the 3-servo 140° type has been selected.
(Pitch)
(Elevator)
When the 4-servo 90° type has been selected.
To Device Select
To Device Select
(Aileron)
(AUX3 = Elevator 2)
(Aileron)