JR ProPo DSX11 Operation Manual page 27

When Intermediate Points have been added, the output
value will be displayed as the value in the situation where
the points above and below this point have been automati-
cally connected by straight lines.
In addition, when the Intermediate Points are set as
shown in the graph at right, the points will be joined by
straight lines. Although it will be possible to freely set a
curve from this condition, the settings should be imple-
mented while considering the following circumstances.
Adjustment should be carried out while fully understand-
ing the Hovering Throttle knob allocation and Throttle Trim
allocation. Care will be required since the graph display
includes the Hovering Throttle knob and Throttle Trim
action.
Further, consideration should be given regarding whether
or not Intermediate Points should be added, together with
the helicopter setting conditions, in order to set curves that
match the purposes to suit each performance.
Throttle Trim Allocation
For the Throttle Trim, it will be possible to increase or
decrease the Point L output as shown in the graph.
Further, as shown in the graph the trim operation will exert
an influence on the operation up to the next point.
Exponential Curve (EXP) Function
Curves are independent for each system, and it is possible
to select a straight line or an exponential curve. By setting
EXP to ON using the dial, the sequential line curve will
become an exponential curve in which the changes in the
output values close to each of the points will become
smoothed. To set this function to OFF, press the dial again
to switch it OFF.
Hovering Throttle Trim Hovering Throttle Trim
Operation Range Operation Range
Throttle Trim Throttle Trim
Operation Range Operation Range
L L 1 1
(Points) (Points)
Low Low Throttle Stick Throttle Stick
Situation of switch position "N" where Situation of switch position "N" where
Intermediate Points have been added. Intermediate Points have been added.
(The Hovering Throttle of Intermediate Points 1, 2, (The Hovering Throttle of Intermediate Points 1, 2,
and 3 are all set to the ON condition.) and 3 are all set to the ON condition.)
Idle Up
Stunt 1, 2, 3, and 4 of the normal Flight Mode switches
should be used for Idle Up.
An aerobatic specification setting example graph is
shown in the Pitch Curve section. This should be
referred to during setting.
Press the dial
(Output Value) (Output Value)
100% 100%
50% 50%
0% 0%
2 2 3 3 H H
High High