JR ProPo DSX11 Operation Manual page 26

THROttle CURVE
Because this transmitter adopts a multipoint adjusting
method for the Throttle Curve and Pitch Curve settings,
various adjustments can be freely carried out to create
throttle curves and pitch curves that will enable ideal flight
conditions.
This transmitter has been designed to carry out static
performance settings using the NORM Flight Mode switch
position, and to implement four systems of mobile perfor-
mance settings using ST1-4.
Before setting this item, first confirm whether or not all the
Point Number
Flight Mode Switch Position
Exponential Curve Function
Fight Mode Switch Position Changeover
The position changeover is carried out using the Flight
Mode switches.
Change over to the Mode that you wish to set, and carry out
the settings.
NORM: Normal
ST-1: Stunt 1
Flight Mode
ST-2: Stunt 2
Switch Position
ST-3: Stunt 3
ST-4: Stunt 4
*In the Throttle Hold condition, setting will not be possible.
About Intermediate Points
At the time of shipment, Intermediate Point 1 is set to the 50
location in all of the Flight Modes, and the operation will be
set as shown in the graph. Note that Intermediate Points
can be set to optional positions, and can be increased to a
maximum of three locations.
In the situation where Intermediate Points are to be added
or deleted from this condition, move the stick to match the
cursor to the location where you wish to make the setting. If
setting is possible, the function key part will display "ADD",
and the point will be added by pressing the key. The Point
name will automatically change to 1 and 2 counting from
the left.
This will change according to the stick position.
No Display: Setting is not possible
servos are to be fixed (HOLD) at their current positions.
Because the throttle stick will be moved in the following
adjustment, select "YES" when the adjustment is to be
carried out while the engine is still rotating. Note that in the
Throttle Hold condition, "HOLD" will be displayed, and
setting will not be possible.
In the situation where this item has been entered through
Servo Hold, in the situation where the item is to be exited
again, set the Flight Mode to NORM and set the throttle
stick to the slowest position.
Corresponding Point Output
Value (0 to 100)
Corresponding Point
Stick Position
Current Stick Position
Point Numerical Value Input
The numerical value setting for each point is also carried
out by rotating the dial to highlight the point that you wish to
set, then pressing the dial so that the point changes to the
condition where it is enclosed by a border as shown in the
figure below. Rotating the dial in this condition increases or
decreases the numerical value. The
pressed in this condition to carry out presetting. When
Clear is carried out, each point will be set to the numerical
values of the stick position of the corresponding point.
Further, to delete a point, in the same way as for the
addition method move the stick to match the cursor to the
point that you wish to delete and press the function key.
Note that in the situation where the point that you wish to
set is located too close to another point, nothing will be
displayed, and setting will not be possible. Avoid setting
unnecessary points as far as possible.
ADD: Add point DEL: Delete point
To Pitch Curve Settings
Graph 1
The display in the figure at left shows
the situation in the standard condition at
the time of shipment when the position
is NORM (Normal), the throttle stick is
centered, the Throttle Trim is in the
slowest position, and the Hovering
Throttle is centered.
Current Output Value
Press the dial.
Hovering Throttle Trim
Operation Range
L
Low Throttle Stick
(Graph 1) NORM (Normal)
Position at the Time of Shipment
(Condition where the intermediate point is only "1")
key can also be
(Output Value) (Output Value)
100 100
50
Throttle Trim
Operation Range
0
1 H
High