Governor - JR ProPo DSX11 Operation Manual

Tail Lock Mode
In the situation when using a gyro with tail lock (heading lock),
changeover will take place so that Tail Lock will be set when the
output amount is 51% or greater, while Normal will be set when
the amount is 49% or less. By highlighting the "NORMAL" part
and pressing the dial, "T.LOCK" will be displayed and it will be
possible to easily carry out sensitivity adjustment of the gyro
with tail lock.
This will be displayed
when two GYRO
outputs are set in
System Mode.
Dual Gain
Gyros such as this company's G7000 Gyro allow the sensitivity
setting channel and the strength of the effect during Tail Lock to
be set using separate channels. By using this function, it will be
possible to switch simultaneously between sensitivity setting
and tail lock setting.
By rotating the dial to select the "TWO GYRO" part shown in
the figure above, then pressing the dial, this function will be
Press the dial
Setting Values and Actual Output Values
0% 0%
NORMAL
-100%
T
-100%
T.LOCK
125%
N
-125%
0%
NORM GAIN
DUAL GAIN -100%
T.LOCK
-100%

Governor

In the Governor Mixing in this transmitter, it is possible to set
mixing amounts separately for each Flight Mode. In addition,
although the transmitter settings set the rates for each Flight
Mode switch position, you should set your desired rotation
speed using the governor main unit.
Current Transmitter Condition (Set to the NORM side)
Channel Display set
Corresponding Mixing
in Device Select
Amount (0 to ±150%)
When in this condition, a "T" mark will be displayed on the left
side of the sensitivity display, and it will be possible to switch
between the "N" Normal side and the "T" Tail Lock side using
this part. In addition, "DELAY" is displayed in the lower part,
and there is a function that will implement a delay of the time
set only in the situation when changing from low gyro sensitivity
to high gyro sensitivity.
Delay Time Setting
selected.
The setting of which channels "NORM GAIN" and "T.LOCK" will
be allocated to is carried out by rotating the dial to highlight the
channel display part. Pressing the dial in this situation will
change between the "NORM GAIN" and "T.LOCK" channels.
The upper numerical values are the
setting values.
0%
0%
0%
100%
0%
OFF
0%
100%
Because the rotation speed adjustment from the transmitter will
be the rate setting, the actual rotation speed should be
confirmed using the display on the governor side.
Setting Method
By rotating the dial to highlight the mixing amount display of the
Flight Mode that you wish to set, then pressing the dial, this
Flight Mode
part will become enclosed by a border. Rotating the dial in this
condition will allow increasing and decreasing of the mixing
Normal
amount.
After determining the numerical values, pressing the dial once
Stunt 1
again will confirm the setting value, and will return to the Item
Stunt 2
Selection condition.
Stunt 3
During the mixing amount adjustment, the
enabled. Pressing the key will return the mixing amount to 0%.
Stunt 4
Throttle Hold
The display at left shows the Throttle Hold function and Flight Mode
Extension function situation, when the Throttle Hold function is set to the
ACT (activated) condition.
: Normal Gain
: Tail Lock Gain
Situation of Tail Lock Gyro
Situation of Normal Gyro
125% 125%
125%
150%
150%
125%
150%
125%
Press the dial
key will be