Mix Monitor; Monitor - JR ProPo DSX11 Operation Manual

MIX MONITOR

Current Flight Mode
Mixing Condition
In this function, it is possible to understand the mixing conditions
for each Flight Mode. Mixing that is being used will be displayed as
"ON", while mixing that is not being used will be shown as "OFF",
and mixing that has not been set is shown as "INH". Further, by
using the dial to move to the mixing item that you wish to change
and pressing the dial, the screen will directly change to the Mixing
Setting screen of this item.

MONITOR

This function is for monitoring the servo operation and
A.D.T. amount of each channel that incorporates a servo
operation testing function using the transmitter display
screen. In the servo operation display, the horizontal line in
the center of the bar display is the neutral position. From
this as the center, graduations for the control surface 50%
and 100% angle positions are marked in order in the up and
down directions, and both ends in the up and down
directions will become the maximum control surface angles
Servo Operation Display
Match the cursor to
and press the dial, or else
press the function key.
Trim Amount Display
Servo Test Operation Changeover
The Servo Test switches between the TEST parts
in the Servo Operation Screen. When the dial is
rotated the items will change as shown in the figure
at right.
NEUTRAL: All servos are neutral
Slow : All servos will operate
slowly at the same time.
Quick : All servos will operate
quickly at the same time.
Step : Each servo will operate on
each side in succession.
In this Servo Testing, only the Limit Adjust will
operate effectively.
Swash Type Setting Condition
of 150%.
The movements in this function will be movements that
include all adjustments and mixing. Regarding each of the
display positions, these should be used as a rough guide.
It is then possible to confirm the trim amounts from the list
of trim amounts that are displayed separately for each
Flight Mode. The screens can be switched using the PAGE
key.
Servo Operation Test
0 %
50 %
100 %
150%
Condition where
setting has not been
carried out
Program Mixing Condition
Channels that are being set:
THROThrottle
AILE Aileron
ELEVElevator
RUDD Rudder
GEAR Gear (Retractable
landing gear)
PIT. Pitch
AUX2Auxiliary (AUX2)
AUX3Auxiliary (AUX3)
AUX4Auxiliary (AUX4)
AUX5Auxiliary (AUX5)
AUX6Auxiliary (AUX6)
---- Setting invali
CH-* Display during Swash Setting
0 %
50 %
100 %
150 %
The figure at left shows the situation
when "Flight Mode" has been set in
Device Select (System Setting Mode).
Test Halted Condition
Press the dial.
All Servos Neutral (Stopped)
Press the dial.
All Servo Test Condition
(Slow Operation)
Press the dial.
All Servo Test Condition
(Fast Operation)
Press the dial.
All Servo Test Condition
(Step Operation)