JR ProPo DSX11 Operation Manual page 87

Situation of INTERNAL
Select the Copy Destination in the same way as for INTER-
NALINTERNAL.
In the situation where the Copy Destination is an SD Card,
input the Model Name for the Copy Destination Model. (For
the input method, refer to the Model Name section.)
In the situation where this Model Name is duplicated, or
if the name is blank, data will not be stored on the SD
Card.
After inputting the Model Name, press the COPY key.
When "All OK!" is shown following the display of "Data
Copying..." the copying will be completed.
Copy Source
In this situation, the
source is the Internal
Memory, Model 1 Glider
DSM
Copy Destination
In this situation, the
destination is the SD
Card, Model Name
"TEST".
Situation of INTERNAL
Switch off the power and connect the trainer cord to the DSC
jack. Then select the Copy Source file, and when the receiv-
ing side TX is ready, press the COPY key.
Model Deletion
Rotate the dial to select "ERASE", then press the dial.
Select the Model that you wish to delete in the same way as
for Model Copy, then press the ERASE key.
By pressing "YES", in response to the display of "Are you
sure?" the Model will be deleted.
SD-CARD

TRANSFER

Existing Model
Existing Model
During data copying