JR ProPo DSX11 Operation Manual page 94

Gear Channel, AUX2 and AUX3 Input Device and Output Condition
Gear Channel
The gear channel (5ch) operation can be selected as a changeover switch. The input
devices that can be selected are all the switches except for the Flight Mode switch
and Trainer switch.
The OUT item selects whether the input part and output part are to be left connected
or disconnected, or else whether to select the output value using another setting
item. In the initial setting, "GYR" has been set.
When ACT is selected, the currently selected input device position will be output.
In the situation where INH has been selected, the output will be fixed at the neutral
position. This can be used as a Program Mixing Slave channel and linked with the
operations of other channels. In addition, because the input device will be indepen-
dent, it will be possible to use this as a Master channel.
By selecting GOV, the Governor Mixing item will be added to the Function Mode, and
setting will become possible.
When GYR is selected, the Gyro item will be added to the Function Mode, and setting
will become possible.
AUX2 Channel
This sets the AUX2 channel (7ch) operation. The setting method and items that can
be selected are the same as for the Gear channel.
AUX3 Channel
This sets the AUX3 channel (8ch) operation.
The output is the same as for the channels described above.
* In the situation where Swash 4-servo 90° has been selected, the AUX3 channel will
be used.
In this situation, the output will be forcibly displayed as "CH8", and output setting will
not be possible.
AUX4, AUX5 and AUX6 Channel Input Device and Output Condition
As the input device, it will be possible to select one from among the AUX4,
AUX5, and AUX6 knobs or the Flight Mode switches, gear switch, AUX2 switch,
or RUDD D/R switch. In the situation where a knob is selected, the knob center
position will be the neutral position in full operation. In the situation where a
3-position switch such as the Flight Mode switch has been selected, because
the switch itself has three positions, this will become three-stage operation
consisting of the left and right maximum operations and neutral. In the case of
the Gear switch, this will have maximum operation to the left and right.
The output device can be selected as "INH" or "ACT".
OUT: In the situation where INH has been selected, the neutral position will be
fixed.
High Pitch Trim Lever Selection
Regarding the high pitch trim operation itself, read the Pitch Curve section
(Function Mode). When OUT is set to ACT, the High Pitch setting item will be
added, and it will become possible to carry out setting.
For the input device, it will be possible to select left and right switching using the
lever, or the AUX6 knob, or INH (inhibited).
In the case of the switching, care will be required to avoid carrying out duplicated
settings.
Cautions during Output Condition Setting
INH: Output invalid
ACT: Output the input device value
GOV: Output the Governor setting value
GYR: Output the Gyro setting value
INH: The output is fixed as neutral. It will
be possible to change the value
using Program Mixing, etc.
ACT: Outputs the input device value.
GOV: Outputs the setting value in the
governor item.
This will be disconnected from the
input device.
Duplicated selection will not be
possible.
GYR: Outputs the setting value in the gyro
item.
In the situation where there are two
gyros, or in Dual Gain, two channels
will be used.
* In the situation where a Tail Lock Gyro
is being used which requires a
two-channel portion of control, use this
function to set the outputs of two
channels to "GYR" beforehand.