Elev → Flap - JR ProPo DSX11 Operation Manual

ELEV→FLAP mix
This mixing is used when you wish to link the flaps when
operating the elevator. By setting the mixing so that the
flaps will lower when the elevator is raised, it will be
possible to increase the lift when the elevator is raised.
Mixing Amount (±125%)
Elevator Operation Direction
D: Down Side
U: Up Side
Throttle Linkage Position Setting (INH, 0 to 100)
Setting Method
First, determine the up side or the down side of the position
that you wish to set. By rotating the dial to highlight the
display part, then pressing the dial, this part will become
enclosed by a border. Rotating the dial in this condition will
allow increasing and decreasing of the mixing amount.
Once the numerical values have been determined, press
the dial once again. This returns to the Selection condition.
In the Numerical Value Setting condition, the
be enabled.
By pressing the key, the mixing amount will return to
zero.
This mixing takes two values, and is always operating.
Normally, the Pos0 side is set to 0% and the Pos1 value is
determined to apply mixing using special switch operation.
It may also be convenient to use this when you wish to
apply mixing while Pos0 is in the normal condition.
It is possible to set the mixing amounts separately for the up
side and down side. In the situation where you wish to
reverse the mixing direction, set the mixing amount to
minus.
Current Transmitter Condition
(Set to the Pos0 side)
Switch Selection
Operation Switch Selection Method
For the lever switch that sets the mixing function ON and
OFF, by rotating the dial to highlight "SW SEL" and then
pressing the dial it is possible to carry out switch selection.
For the setting method, refer to the items in section [6]
Servo Speed.
Throttle Stick Linkage Setting
key will
It is possible to set the mixing changeover point to an
optional position on the throttle stick. For example, when
this point is set to 50, moving the stick up above the center
will take the Pos0 value, while moving the stick below the
center will become the Pos1 value.
Note that it is possible to set the preset to INH (inhibited
condition) using the key.