JR ProPo DSX11 Operation Manual page 38

Mixing 4-6 Curve Mixing Settings
In the situation where Mixing 4-6 has been selected, first select whether Normal
Mixing or Curve Mixing is to be used. In the case where Normal Mixing is
selected, read the previous section.
After the selection, you should select whether or not Servo Hold is to be applied.
Answering "YES" sets all the servos to Hold.
For the Channel setting and Mixing Switch selection, refer to the explanation in
the previous item.
Master Channel (Channel
that applies the mixing)
Mixing Switch
Selection
The + means that the Mixing Trim which is
applied to the Master Channel will also be
included.
# means that the Mixing Trim is not included.
Point Numerical Value Input
Also for the numerical value settings of each point, rotate
the dial to highlight the point that you wish to set and press
the dial to change the point to the condition where it is
enclosed by a border as shown in the figure below. Rotating
the dial in this condition will increase or decrease the
numerical values. While in this condition, it is also possible
to return to the preset values using the
is carried out, each point will become the numerical value of
the stick position of the corresponding point.
Press the dial.
About the Intermediate Points
At the time of shipment, Intermediate Point 1 is set to the 50
location in all of the Flight Modes, as shown in the figure.
Note that Intermediate Points can be set to optional
positions, and the points can be increased to a maximum of
three locations.
In the situation where Intermediate Points are to be added
or deleted from this condition, move the stick to match the
cursor to the location where you wish to make the setting. If
the setting is possible, the function key part will display
"STO", and the point will be added by pressing this key. The
point name will automatically change to 1 and 2 counting
from the left.
Switch Selection
Slave Channel (Channel to
which mixing is applied)
Exponential Curve (EXP) Function
This curve mixing allows selection of successive line curves
(initial setting) using straight lines between each point, or
linking the points by smooth curves. Setting EXP to "ON"
using the dial will change the straight lines to exponential
curves in which the changes in the output values close to
the points will become smoothed. To set this function to
key. When Clear
invalid, press the dial once again to switch it OFF.
Further, in the situation where a point is to be deleted, as
with the point addition method move the stick to match the
cursor to the point that you wish to delete and press the
function key. Note that in the situation where the point that
you wish to set is located close to another point, nothing will
be displayed, and setting will not be possible. Avoid setting
unnecessary points as far as possible.
Press the dial
Corresponding Point
Output Value (0 to ±100) Graph Display
Current Input Value
Exponential
Current
Curve Function
Input Value
Select Normal Mixing
Select Curve Mixing
Current
Output Value